Do not operate the flexible shaft with a sharp
bend (A). This can generate excessive heat and will reduce tool and
recommended minimum is 6" radius (El). Contents of 53033
Description
1
1Driver Cap
Cutting Guide53141
The cutting guide (sold separately) comes completely assembled and ready to use. For use in a variety of materials up to 3/4" thick. Match the bit type to the material to be cut. Always hold the tool firmly, using slow
53134
Drywall Cutting Bit
For use in drywall.
• When inserting the 53134 bit into your Craftsman Rotary tool, make sure that the bit has been inserted as far as possible.
=When making freehand cuts in drywall, - ex., repairing a hole in drywall. When using a template (outlet box) behind the drywall,
use the Drywall Cutting Bit 53134, cutting
in a
53135
Multipurpose Cutting Bit
For use in wood, plastics, drywall,
fiberglass, vinyl or aluminum siding, acoustical tile and laminates.
•When inserting the 53135 bit into your Craftsman Rotary tool, make sure that the bit has been inserted as far as possible.
•When making freehand cuts in use the
Multipurpose Cutting Bit 53135, cutting in a clockwise direction.
A.B.
steady pressure to make cuts.
To attach, follow the four steps shown below.
Important: Always cut in a clockwise direction, except when following a
template (outlet box), then cut in a
counterclockwise direction,
•When using 53135, Multipurpose Cutting Bit, start the bit into the material at a 45 degree angle and then slowly bring it to a 90 degree angle to begin the cut.
53136
Tile Cutting Bit (Not Included)
For use on wall tile, cement board and plaster
•When inserting the 53136 bit into your Craftsman Rotary tool, it is very important that
•When using 53136, Tile Cutting Bit, start the bit into the material at a 45 degree angle and then slowly bring it to a 90 degree angle to begin the cut.
•NOT FOR USE ON FLOOR TILE
17
