Find out if the remote can operate your TV

RCA DRC8005N Find out if the remote can operate your TV, Direct Entry, Automatic Code Search

Chapter 2: The Remote Control

DVD

ON• OF F

SAT• C A BLE	TV	ON•OFF button
SAT• C A BLE	TV
		TV button
	RETU R N
VOL		CH
MUTE	G O• B A CK
CLEAR		MEN U
OPEN• CLOSE		ANGLE
ZO OM	TIMER• GUIDE
	INFO
1	2	3
4	5	6
7	8	9
INPUT	0	ANTEN NA
	0
REVERSE	PLAY	FORWAR D
RECOR D	STOP	PAUSE
AGAIN	LIVE	ADVANCE

Find out if the remote can operate your TV

This remote control is designed to operate most RCA, GE, and Proscan TVs.

1.Press the TV button.

2.Press the ON•OFF button (if the TV turns on or off, this remote will operate the TV).

3.If that doesn’t work, you can try programming the remote by following the instructions below.

Programming the remote to operate your TV

There are two ways to program this remote control to operate other brands of TVs: Direct Entry and Automatic Code Search (both methods are described below).

Direct Entry

1.Turn on the TV.

2.Look up the brand and code number(s) from the list on page 21.

3.Press and hold the TV button on the remote.

4.Keep holding down the TV button, and enter the first code from the code list for your brand (p. 21).

5.Release the TV button.

6.Point the remote toward the TV and press the ON•OFF button to see if the TV turns off. If it doesn’t, press the TV button and then press ON•OFF. If you get no response, follow steps 1-5 again, but enter the next code from the code list for your brand of television.

Note:This remote may not be compatible with all brands and models of televisions.

DVDON• OF F

SAT• C A BLE	TV
	RETU R N
VOL		CH
MUTE	G O• B A CK
CLEAR		MEN U
OPEN• CLOSE		ANGLE
ZO OM	TIMER• GUIDE
	INFO
1	2	3
4	5	6
7	8	9
INPUT	0	ANTEN NA
	0
REVERSE	PLAY	FORWAR D
RECOR D	STOP	PAUSE
AGAIN	LIVE	ADVANCE

ON•OFF button

TV button

Indicator light

PLAY button

Automatic Code Search

The Automatic Code Search method tests all of the codes for a specific component button. If you want to stop the automatic code search without programming any of your components, press CLEAR until the indicator on the remote turns off.

1.Turn on the TV.

2.Press and hold the TV button.While you continue pressing the TV button, press and hold the ON•OFF button until the indicator light on the remote turns on— then release both buttons.

3.Point the remote at the TV. Press and release PLAY, then wait 5 seconds or until the indicator on the remote stops flashing.

At this point the remote is searching for the correct code to program (you’ll know it’s found the correct code when the TV turns off, go to step 4). If, after 5 seconds, the TV doesn’t turn off, press PLAY again to tell the remote to search the next set of codes.

Continue pressing PLAY until the TV turns off or you have searched through all of the codes.There are 20 total sets of codes. If the component does not turn off after pressing PLAY 20 times, then the remote can’t be programmed to operate your brand of TV— you’ll have to use the remote that came with your TV.

4.When the TV turns off, the remote has found the proper code. Press and release REVERSE, then wait 2 seconds. Repeat this step until the TV turns back ON.

5.To finish, press and hold STOP until the indicator on the remote turns off.

REVERSE button

STOP button

Graphics contained within this publication are for representation only.