Detachable Control Panel DCP, Attaching the DCP

DV2011

3.Remove the factory mounting

	brackets and hardware from the
	existing radio and attach them
	to the new radio. Select a
	position where the screw holes	Screws
	of the bracket and the screw	Screws
	of the bracket and the screw
	holes of the main unit are	Dashboard
	aligned (are fitted). Tighten the	Dashboard
	aligned (are fitted). Tighten the
	screws at 2 places on each
	side. Do not exceed M5 x 9 MM	Factory
	maximum screw size. Longer	Factory
	maximum screw size. Longer	Mounting
	screws may damage	Mounting
	screws may damage	Bracket

	components inside the chassis.	Hook (Remove)
	4. Wire the new radio to the	Hook (Remove)
	4. Wire the new radio to the
	vehicle as outlined in the
	Universal Installation instructions.

Detachable Control Panel (DCP)

Removing the Detachable Control Panel (DCP)

1.Turn the power off.

2.Press the REL button.

3.Remove the DCP.

Attaching the DCP

1.Attach the panel at the right side first, with point B on the main unit touching point A on the DCP (as shown in the diagram).

2.Press the left side of the DCP onto the main unit until a “click” is heard.

CAUTION:

PANEL RELEASE BUTTON

5.When wiring is complete, reconnect the battery negative terminal.

6.Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1.

NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation.

Removing the Unit (Method A Installation)

To remove the radio after installation:	Dashboard
1. Insert fingers into the groove in the front of
frame and pull out to remove the frame.
(When re-attaching the frame, point the side
with a groove downwards and re-attach.)

•DO NOT insert the DCP from the left side. Doing so may damage it.

•The DCP can easily be damaged if dropped or subjected to a strong shock. When the release button is pressed and the DCP is unlocked, the vehicle's vibrations may cause it to fall. To prevent damage to the DCP, always store it in a protective case after detaching it.

•The rear connector that connects the main unit and the DCP is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.

•If the DCP is dirty, remove debris with a soft, dry cloth only. You can use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the DCP.

2.Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit.

Sleeve

Removal Key