FOR YOUR GUIDANCE
■Service
Before requesting service, please refer to the troubleshooting guide on previous page to determine the symptoms. To obtain service please contact your local Panasonic dealer quoting the model number and serial number (both are located at the rear of the receiver).
■Last Position Memory
Certain functions have a last position memory, i.e. the setting at the time of switch - off will be the setting used when the receiver is switched on again:
ProgrammeTint
Headphone volume | (M.NTSC/NTSC only) |
■Sleep Feature
If the set is not switched off when the TV station stops transmitting, it will automatically go to standby mode after 30 minutes. This function will not operate when the receiver is in AV mode.
AV position | Contrast |
Volume | Sharpness |
MPX | Aspect (except 4:3) |
Bass | Standby |
Treble | Artificial Intelligence (AI) |
Balance | (Picture & Sound) |
Status | Colour |
Teletext mode | Brightness |
Decoder (AV2) | |
Volume correction | |
| (in AV mode only) |
SPECIFICATIONS
|
| TU - PTA100E |
Power Source |
| 220 V - 240 V 50 Hz/60 Hz A.C. |
|
|
|
Power Consumption |
| 23 W |
|
|
|
Standby Consumption |
| 2.8 W |
|
|
|
| 2.1 W | |
|
|
|
RGB Output |
| 0.7 |
|
|
|
AUDIO Output |
| 0.5 V[rms] (Volume max) |
|
|
|
Dimensions | H | 121.4 mm |
W | 430 mm | |
| D | 349.5 mm |
|
|
|
Weight (kg) |
| 5.1 kg |
| PAL B, G, H, I, SECAM B, G SECAM L/L’ | ||
|
| VHF E2 - E12 | VHF H1 - H2 (ITALY) |
|
| VHF A - H (ITALY) | UHF E21 - E69 |
|
| CATV (S01 - S05) | CATV S1 - S10 (M1 - M10) |
Receiving Systems/ |
| CATV S11 - S20 (U1 - U10) CATV S21 - S41 (Hyperband) | |
PAL D, K, SECAM D, K |
| ||
Band name |
| VHF R1 - R2 | VHF R3 - R5 |
|
| VHF R6 - R12 | UHF E21 - E69 |
| PAL 525/60 Playback of NTSC tape from some PAL video recorder (VCR) | ||
| M.NTSC | Playback from NTSC 4.43 MHz Videorecorders (VCR) | |
| NTSC (AV mode only) Playback from NTSC Videorecorders (VCR) | ||
|
|
|
|
Aerial - Rear |
|
| UHF/VHF |
|
|
|
|
Headphones - Front |
|
| 3,5 mm., 8 Ω impedance |
|
|
| |
AV - Rear |
| AV1 21 pin terminal - Audio/Video in/out RGB in. | |
| AV2 - 21 pin terminal - Audio/Video in/out, | ||
|
| ||
|
| AV4 - 21 pin terminal - Audio/Video in/out, | |
|
|
| |
AV - Front |
| AV3 - |
BSpecifications are subject to change without notice. Weight and dimensions shown are approximate.
This equipment complies with the EMC standards listed below.
EN55013, EN55020
31