Panasonic TC-L37DT30 Display the menu Select Network settings, Select the settings and set

Network settings

This is a setting for connecting to a broadband environment.

Display the menu

Select “Network settings”

Menu Setup 1/2 select

3D settings Channel surf mode

All

Language

Clock

ANT/Cable setup

Input labels

Network settings

■Press to exit from	VIERA Link settings
a menu screen

■Press to go back to the previous screen

Select the settings and set

			select
Menu	Network settings
	Connection test		adjust
	Network connection	Wireless (WiFi)
	Wireless network
	IP address/DNS settings
	Network link
	Network cameras list
	Software update
	Mac address	00-0b-97-7c-65-e9

Connection test

Check that the Network settings are as shown below, and then start “Connection test”.

Select “Connection test” and press OK

(It takes a while to cancel the test.)

Displayed Connection test screen

Connection test

Check Ethernet cable connection

Validate IP address

Check for IP address duplication

Check connection to the Internet

Check communication with VIERA Connect server.

Test in progress...

Complete Connection test

Success-->Completion screen is displayed.

Error-->Follow the directions on screen to complete the setting. If you perform the Proxy settings, check the Proxy address and the Proxy port number.

Network connection

Select Network type (Ethernet cable/Wireless (WiFi))

Wireless network (Confirm Current settings and status)

This setting is performed only when “Wireless (WiFi)” is selected in “Network connection” above.

■Displayed “Current settings and status” screen (If connected with Wireless LAN Adapter)

You can confirm the AP connection status.

(SSID/Wireless type/Security type/Encryption type/Connection status /Signal strength)

Press “Wireless network”

Wireless network select

SSID : Wireless type :

Security type:

Encryption type : OK

Connection status : Signal strength :

Connect using these settings?

YesNo

When you change “Wireless network” -->Press “No”

See “Sets / Changes wireless network setting” on p. 41 and follow the directions on screen to complete the setting.

You need to be “Connected” to use network devices. Please set Access point settings to “Connected”.

40

(example)