Remote Control Batteries Installation

AC Power Cord Connection

This LCD TV uses nominal input voltages of 110-127V AC. It is designed to work with single-phase power systems. To reduce risk of electrical shock, do not plug into any other type of power system. Consult your authorized dealer or service station if you are not sure the type of power being supplied. Connect the LCD TV with all peripheral equipment before turning the LCD TV on.

Caution

• For safety, unplug AC power cord when the LCD TV is not in use.

1.Remove the battery compartment cover.

2.Insert two size AAA batteries (1.5V) according to “+” and “-” polarity markings inside the battery compartment.

3.Close the battery compartment cover.

Antenna or Cable Connection

Cable used for connection (This Outdoor Aerial cable is not

supplied• with this LCD TV.) Aerial Cable

PC AUDIO

via AUDIO IN

AV IN

COMPONENT

ST3

•ATSC is not available except in U.S.A., Canada, and/or Mexico.

•For all aerial circuit problems, please consult your local dealer.Note:

Caution

To insure safe operation, please observe the following

•Replace two batteries at the same time.

•Do not use a new battery with a used battery.

•Avoid contacting with water or liquid.

•Do not expose the Remote Control or Batteries to moisture, or heat such as sunshine, fire or the like.

•Do not drop the Remote Control.

•If a battery has leaked on the Remote Control, carefully wipe case clean and install new batteries.

•Risk of explosion if battery is replaced by an incorrect type.

•Dispose of used batteries according to the instructions.

•Remote control contains AAA battery and must be kept out of reach of small children to avoid accidental ingestion.precautions: