Panasonic TC-L24X5 owner manual Troubleshooting, No Power

TROUBLESHOOTING

Before calling your dealer or service center for assistance, check the matters below once again.

1.Make sure you have connected LCD TV to your equipment.

2.Check cable connection. Verify that all external equipment and power cords are properly connected.

3.Verify that all power is switched on.

4.If LCD TV still does not produce an image, re-start the external equipment.

5.If the image still does not appear, unplug LCD TV from the external equipment and check the external equipment. The problem may be with your graphics controller rather than with LCD TV. (When you reconnect LCD TV, remember to turn the external equipment and TV off before you power up LCD TV. Power the equipment back on in order of LCD TV and external equipment.)

6.If the problem still exists, check the following chart.

Problem	Try these Solutions
NO POWER	• Plug this LCD TV into the AC
	outlet.
	• Press POWER button on side
	control or on Remote Control to
	turn on LCD TV.
	• Check POWER Indicator. If this
	indicator no light, this TV has
	getting trouble.
Remote Control does	• Check the batteries.
not work	• Make sure nothing is between
	the Remote Receiver and the
	Remote Control.
	• Make sure you are not too far
	from LCD TV when using Remote
	Control.
	• Maximum operating range is
	(7m and a 30 degree angle of the
	front of the TV).
	• Is direct sunlight or strong
	artificial light shining on LCD
	TV‘s Infrared Remote Receiver?
	Eliminate the light by closing
	curtains, pointing the light in a
	different direction, etc.
	• A dedicated remote control is
	required for this model. Basically,
	the remote control of other
	brands (including Panasonic
	other models) cannot be used.

Problem	Try these Solutions
No image	• Check the connection between
	the external equipment and
	LCD TV.
	• When turning LCD TV on, it takes
	a few seconds to display the
	image.
	• Check the system that you
	select is corresponding with the
	external equipment or the video
	equipment.
	• Make sure the temperature
	is not out of the Operating
	Temperature 32 °F - 95 °F
	(0 °C - 35 °C).
	• Turn off power, then turn on
	again, re-start LCD TV.
No sound	• Check Audio cable connection
	from Audio input source.
	• Adjust the Sound System.
	• Press VOLUME (+) button.
	• Press MUTE button.
There are tiny black	• Dark or bright points of light (red,
points and/ or bright	green, or blue) may appear on
point on the TV	the screen. This is a characteristic
	of the LCD panel, not a
	malfunction of the LCD TV.
	• LCD panel is produced with very
	high accuracy technology. There
	is 99.99% or more dot pixel, but
	there is also 0.01 % or less of
	dot pixel lack or dot pixel that
	is constantly lighted. This is not
	defect.
	• Regarding LCD panel
	characteristic, it may occur
	picture remain (look like a mirror)
	when the screen is changed if it
	displays same screen for a long
	time. Changing the picture or
	turn-off the power supply may
	recover.
	• Stripe pattern (more, interference
	stripes) may show up on the
	screen depends on the reflected
	picture.
Abnormal color of	• Adjust the value of color.
image

Warning

High voltages are used to operate this LCD TV. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased LCD TV or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.

19