Panasonic TC-L24C3 Safety Precautions, Secure Ventilation, Important Safety Instructions

Page 4
POWER SERVICE GROUNDING ELECTRODE SYSTEM
(NEC ART 250, PART H)

Safety Precautions

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: To reduce the risk of electric shock, do not remove cover or back. No user-serviceable parts inside. Refer servicing to qualified service personnel.

The lightning flash with arrowhead within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons.

The exclamation point within a triangle is intended to tell the user that important operating and servicing instructions are in the papers with the appliance.

Note to CATV System Installer

This reminder is provided to direct the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Secure Ventilation

Slots and openings in the cabinet and the back or bottom are provided for ventilation, and to ensure reliable operation of the LCD TV and to protect it from overheating. These openings must not be blocked or covered. There should be at least 10 cm of space around the TV. The openings should never be blocked by placing the LCD TV on a bed, sofa, rug or other similar surface. This LCD TV should not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.

Important Safety Instructions

1)Read these instructions.

2)Keep these instructions.

3)Heed all warnings.

4)Follow all instructions.

5)Do not use this apparatus near water.

6)Clean only with dry cloth.

7)Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8)Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9)Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10)Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11)Only use attachments / accessories specified by the manufacturer.

12)Use only with the cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus.

When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from tip-over. 13) Unplug this apparatus during lightning storms or when unused for long periods of time.

14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into

the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15)Operate only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home consult your television dealer or local power company.

16)Follow all warnings and instructions marked on the LCD TV.

17)Never push objects of any kind into this LCD TV through cabinet

slots as they may touch dangerous voltage points or short out parts

EXAMPLE OF ANTENNA

 

that could result in a fire or electric shock. Never spill liquid of any

GROUNDING AS PER

 

kind on the LCD TV.

(NEC) NATIONAL

ANTENNA

18) If an outside antenna is connected to the television equipment,

ELECTRICAL

CODE

LEAD-IN WIRE

be sure the antenna system is grounded so as to provide some

GROUND CLAMP

 

protection against voltage surges and built up static charges.

 

 

 

ANTENNA

In the U.S. Section 810-21 of the National Electrical Code

 

 

provides information with respect to proper grounding of the mast

ELECTRIC

DISCHARGE UNIT

(NEC SECTION 810-20)

and supporting structure, grounding of the lead-in wire to an

SERVICE

GROUNDING

antenna discharge unit, size of grounding conductors, location of

EQUIPMENT

antenna discharge unit, connection to grounding electrodes, and

 

 

CONDUCTORS

 

 

(NEC SECTION 810-21)

requirements for the grounding electrode.

 

 

 

 

GROUND CLAMPS

 

 

 

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents English Español Inches measured diagonally24,0 pulgadas medidas diagonalmente VieraSD memory card Camcorder Personal computerCable box DVD PlayerContents Important Safety Instructions Safety PrecautionsSecure Ventilation Times Responsible Party Panasonic Corporation of North America Contact SourceViera Consumerproducts@panasonic.comAccessories/Optional Accessory AccessoriesOptional Accessory AccessoriesInstalling the remote’s batteries Attaching the pedestal to TVDo not disassemble or modify the pedestal Do not burn or break batteriesConnections ConnectionsConnection Panels Antenna or Cable connectionAV cable connection Audio connectionPC / Computer connection VGA For HDMI-ARC Audio Return Channel connection, see pTV controls/indicators Remote controlIdentifying Controls ControlsFirst Time Setup Turn the TV On with the Power buttonConfigure your viewing mode Select your languageAuto channel setup ANT/Cable setup Started First Time SetupComplete the Auto program setup Select the connected Antenna in terminalComplete the First time setup Adjust the Clock Set clockGive names to the TV’s inputs Label inputs Watching TV Turn power onSelect a channel number Display the SUB Menu Change aspect ratio and Zoom the pictureCall up a favorite channel Password setting/entering Switches input modeEntering characters Watching TVDisplay Viera Tools Select the item Using Viera ToolsSet each item Display the Input select menu Select the input mode Label each input Select Input labels in SetupPC adjustments p From external devicesInsert the SD card Display Viera Image ViewerSelect the data to be viewed ViewPhoto settings SortViera LinkTM Hdavi ControlTM VersionHdmi cable Equipment onlyViera Link Connections with Viera Link function Viera LinkTM Hdavi ControlTMAdvanced Display the menu Select Viera Link settings in Setup Viera Link settings and Available featuresSelect Viera Link Press to go back to the previous screenAutomatic Input Switching Power on linkPower off link Energy saving modeViera Link menu and Available features Display the Viera Link menuSelect Press to go back to the previous ScreenSetSpeaker control Viera Link control only with the TV’s remote controlBack to TV Editing and Setting Channels Display the menu Select SetupSelect ANT/Cable setup ANT/Cable setup and operationSignal meter Check signal strength Setting ChannelsManual program Set manually How to Use Menu Functions Adjust or select a menu itemDisplay the menu Select the menuHow to Use Menu Functions Audio settings Adjust Audio quality Settings Items Item Description Mode Off Channel ModeProgram Mode PasswordSetup Other function settings Ratings List for parental control How to Use Menu Functions Support InformationTo reset the aspect ratio OK Aspect Ratio Technical InformationAspect Ratio Format SizeInformation Support Digital Audio OUT terminal Hdmi connectionClosed Caption CC Technical Information Support Information Input signal that can be displayedPC Input Terminals Connection Care and Cleaning Power cord plugDisplay panel CabinetSpecifications Questions Answers Change settings of Closed Caption CC. pEnsure all connections are correct and secure Frequently Asked Questions Support Information QuestionsIndex Limited Warranty Coverage On-Site or Carry-in ServiceLimited Warranty Limits And Exclusions Carry-InCustomer Services Directory United States and Puerto Rico Accessory Purchases United States and Puerto RicoLimited Warranty for Canada Panasonic Product Limited WarrantyTop View Side Panel Front View Side View Back ViewAnotación del cliente Customer’s RecordAmbler Drive
Top Page Image Contents