WARNING/CAUTION (3D Eyewear)
WARNING ■Disassembly
● Do not disassemble or modify the 3D Eyewear.
CAUTION ■3D Eyewear
● Handle the tips of the frame carefully when putting on the 3D Eyewear as inserting the tip of the frame into the eye may cause injury.
● Be careful not to close the hinge section of the 3D Eyewear on your finger.
Doing so may result in injury.
• Provide supervision when children are using this product.
■Use of 3D Eyewear
● Parents/guardians should monitor children’s viewing habits to avoid their prolonged use without rest periods.
● In commercial application and public viewing, someone in authority should convey the precautions and monitor the user of the 3D Eyewear.
● Use only the 3D Eyewear recommended for this TV. ● Only use the 3D Eyewear for its intended 3D
content viewing purpose.
● Do not move around while wearing the 3D Eyewear.
The surrounding area appears dark, which may result in falling or other accidents that may cause injury.
● Inspect the 3D Eyewear for damage before each use. ■Viewing of 3D Images
● In the event that you experience dizziness, nausea, or other discomfort while viewing 3D images, discontinue use and rest your eyes.
• When you set the effect by using “3D adjustment”, take into account that the vision of 3D images varies among different individuals.
● Do not use if the 3D Eyewear is cracked or broken. ● Content for 3D viewing includes commercially available
● When preparing your own 3D content, ensure that it is properly produced.
FCC and IC STATEMENT
This equipment has been tested and found to comply with the limits for an Other Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the Panasonic Service Center or an experienced radio/TV technician for help.
FCC Caution:
To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of North America could void the user’s authority to operate this device.
FCC and Industry Canada (IC) RF Exposure Warning :
•This TV is provided with two
•These transmitters comply with FCC and IC radiation exposure limits set forth for an uncontrolled environment for mobile use with minimum 8 inches (20 cm) spacing requirement between transmitters and all person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.
•This TV may also be provided with a VIERA Touch Pad Controller approved under FCC ID: MG3- 0602284 / IC
•Other
<Only for wireless LAN if capable of transmission in the 5.15 ~ 5.25 GHz frequency band> This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.
FCC and IC require this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to
Responsible Party: | Panasonic Corporation of North America |
| One Panasonic Way, Secaucus, NJ 07094 |
Contact Source: | Panasonic Consumer Marketing Company of North |
| America |
| |
email: | consumerproducts@panasonic.com |
This device complies with Part 15 of the FCC Rules and all applicable IC RSS standards. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
6