Panasonic TC-P54G25, TC-P42G25, TC-P46G25, TC-P50G25 quick start Complete Connection test

Check that the Network settings are as shown below, and then start “Connection test”.

Select “Connection test” and press OK					Displayed Connection test screen
(It takes a while to cancel the test.)
					Connection test
Menu Network settings			select		Check Ethernet cable connection
	Connection test				Validate IP address
					Check for IP address duplication
	Network connection Wireless (WiFi)				Check connection to the Internet
					Check communication with Viera CAST server.
	Wireless network	- - -	OK		Test in progress...
	IP address/DNS settings
	VIERA CAST setting				Complete Connection test
	Network cameras list
	Software update			Success->Completion screen is displayed.
	Mac address	00-0b-97-7c-65-e9
				Error-->Follow the directions on screen to complete the setting.
	Checks for proper network connection,
	settings and communication to the Internet &			If you perform the Proxy settings, check the Proxy address and
	server.			the Proxy port number.

Select Network type (Ethernet cable/Wireless (WiFi))

This setting is performed only when “Wireless (WiFi)” is selected in “Network connection” above.

Press “Wireless network”, displayed screen

(only when “---”, “No adapter” or “None” is displayed) Set the following connection.

Please select the connection with your wireless LAN adapter and Access point.

Follow the directions on screen to complete the setting

Wireless network

Please choose a connection method.

WPS (Wi-Fi Protected Setup using push button) WPS (Wi-Fi Protected Setup using PIN number) Search for wireless networks Manual settings

select

OK

WPS (Wi-Fi Protected Setup using push button):

Wi-Fi Protected Setup is an easy setting of the Wi-Fi Alliance’s certification. You can connect the Access point to press the buttons.

WPS (Wi-Fi Protected Setup using PIN number):

Set the PIN code that is displayed on the TV on the access point. (For more details on setting of Access point, please refer to operating manual for the Access point.)

Search for wireless networks:

Select an access point from the ones searched for automatically, and configure the settings as instructed on the screen.

Manual settings:

Manually set SSID, Security type, and Encryption type to match the settings of the access point to which to connect.

*When connecting by 11n (5 GHz), select “AES” as the Encryption type for the wireless LAN.

Displayed Connection status with an Access point

Wireless network	- - -	- - - : Connect with LAN cable
		No adapter:	Wireless LAN adapter is not installed.
		None:	There are no settings to connect Access point.
		Connecting…: Currently connected to Access point.
			If “Connected” is not displayed after a while,
			set the access point connection settings again.
		Connected:	Complete connection.

Displayed “Current settings and status” screen (only when “Connected” or “Connecting…” is displayed) You can confirm the AP connection status.

(SSID/Wireless type/Security type/Encryption type/Connection status /Signal strength)

Network Settings

Advanced

Press “Wireless network”

Wireless network

Current settings and status

SSID :

Wireless type :

Security type:

Encryption type :

Connection status :

Signal strength :

Continue with current settings?

YesNo

select

OK

When you change “Wireless network” -->Press “No”

Follow the directions on screen to complete the setting.

You need to be “Connected” to use network devices. Please set Access point settings to “Connected”.

(example)
The Network settings become effective when you close the menu and run “Connection test”.	43