Panasonic TC-L47DT50 Location, Power cord connection, Installing the remote’s batteries

Removing the pedestal from the TV

Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.

Spread out a blanket or other such soft material onto a work surface such as a desk, and place the TV screen side down on the blanket.

To work safely, hold the TV as described in of Set-up (p. 9) and place it on a workbench. Remove the assembly screw from the cover.

Pull out the cover.

Remove the assembly screws from the TV.

Pull out the pedestal from the TV.

Remove the assembly screws from the bracket.

WARNING

Do not disassemble or modify the pedestal.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Caution

Do not use any pedestal other than that provided with this TV.

Otherwise, the TV may fall over and become damaged, and personal injury may result.

Do not use the pedestal if it becomes warped or physically damaged.

If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.

During set-up, make sure that all screws are securely tightened.

If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV, and it might fall over and become damaged, and personal injury may result.

When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (p. 9)

Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.

Location

Place the TV at a comfortable distance for viewing. Avoid placing it where sunlight or other bright light (including reflections) will fall on the screen. Use of some types of fluorescent lighting can reduce remote control transmitter range. Adequate ventilation is essential to prevent an internal component failure. Keep away from areas of excessive heat or moisture.

Adjust the LCD panel		TC-L47DT50
		a: 11.7 ” (295 mm)
to your desired angle.	15°
	a	b: 17.0 ” (430 mm)
	15°	TC-L55DT50
	b
		a: 13.5 ” (341 mm)
	(View from above)
Note		b: 18.7 ” (475 mm)

Ensure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range. Do not place any objects or hands within the full rotation range.

Power cord connection

Insert the power cord plug (included) firmly into place.

• When disconnecting the power cord, be absolutely sure to disconnect the power cord plug from the wall outlet first.

• The included power cord is for use with this unit only.

Installing the remote’s batteries

Pull open

	Note the correct
Hook	polarity (+ or -).

10

Close Caution

Incorrect installation may cause battery leakage and corrosion, resulting in damage to the remote control.

•Do not mix old and new batteries.

•Do not mix different battery types (such as alkaline and manganese batteries).

•Do not use rechargeable (Ni-Cd) batteries.

Do not burn or break batteries.