Panasonic TC-P42C1, TC-P50C1 Size, Side bars, Scrolling bar, Input signals that can be displayed

Technical Information (Continued)

H size

Aspect Ratio: 4:3

Size 1

Size 2

The width will be decreased on both sides to reduce noise.

Aspect Ratio: FULL/JUST(H-FILL/ZOOM)

Size 1	Size 2	The width will be increased on both sides to
		reduce noise.
See pages 26-27 for more information

4:3 side bars

Do not display a picture in 4:3 mode for an extended period, as this can cause “Image retention” to remain on either or both sides of the display field.

To reduce the risk of such “Image retention”, change the brightness of the side bars.

See pages 28-29 for more information

The side bar may flash (alternate black/white) depending on the picture. Using Cinema mode will reduce such flashing (See below).

Side Bar Image retention

4:3

Screen Display

Scrolling bar

Scrolling bar: To prevent “Image retention”, scrolls white vertical bar from left to right on a black screen.	[Scrolling bar]
Press any key except the POWER key to return to previous screen.
You will return to the previous screen if no key operation has been performed for 15 minutes.
See pages 28-29 for more information

Input signals that can be displayed

* Mark: Applicable input signal for Component (Y, PB, PR) and HDMI

horizontal

frequency (kHz)

vertical

frequency (Hz)

COMPONENT

HDMI

525 (480)			/ 60i	15.73	59.94	*	*
	525 (480)		/60p	31.47	59.94	*	*
	750 (720)		/60p	45.00	59.94	*	*
	1,125	(1,080) /60i		33.75	59.94	*	*
	1,125	(1,080)/60p		67.43	59.94		*
	1,125	(1,080)/60p		67.50	60.00		*
	1,125(1,080)/24p			26.97	23.98		*
	1,125(1,080)/24p			27.00	24.00		*

Note

Signals other than those shown above may not be displayed properly.

The above signals are reformatted for optimal viewing on your display.

48