Panasonic TX-32LX500A, TX-26LX500A manual Troubleshooting, Symptoms Checks Picture Sound

Troubleshooting

If there is a problem with your LCD TV please refer to the table below to determine the symptoms, then carry out the suggested check. If this does not solve the problem, please contact your local Panasonic dealer, quoting the model number and serial number (both found on the rear of the TV).

	Symptoms		Checks
	Picture	Sound
	Snowy Picture	Noisy Sound	Aerial location, direction or connection
	Multiple Image	Normal Sound	Aerial location, direction or connection
			Electrical appliances
	Interference	Noisy Sound	Cars / Motorcycles
			Fluorescent lights
	Normal Picture	No Sound	Volume level
			Sound mute switched on.
			TV set to AV mode
			Not plugged into AC outlet.
	No Picture	No Sound	Not switched on.
			Picture / Sound controls set at minimum levels.
			Check if in Standby mode.
	No Colour	Normal Sound	Colour Controls set at minimum levels.
			Colour system
	Poor or Distorted	Weak or	Retune Channel (s).
	Picture	No Sound
	Normal Picture	Weak or	Sound reception may have deteriorated.
		distorted sound	Sound system
			This is a characteristic of liquid crystal panels and is not a
There may be red spots,			problem. The liquid crystal panel is built with very high precision
		Normal Sound	technology giving you fine picture details. Occasionally, a few
blue spots and green			non-active pixels may appear on the screen as a fixed point of
spots on the screen
			blue, green, or red.
			Please note this does not affect the performance of your LCD.
			HDMI cable is not connected securely.
	Poor Video.		Turn the power supply of the TV and connected equipment off
			then turn on.
	(Snow noise, no picture, picture runs, etc.)
H			Check compatibility of input signal from the connected equipment.
D			The connected equipment must be EIA/CEA-861/861B compliant.
M			Change the audio setting of the connected equipment to L.PCM.
I	Poor Audio.		Check the setting of HDMI input in Sound menu.
			If the problem is due to the digital audio connection, change to
			the analogue audio connection.
	The error message appears.		Please consult an Authorized Service Center.
The SD card cannot be used even when it is formatted.			Please consult an Authorized Service Center.

36