Tuning your VCR and satellite receiver
Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart connection is preferable if the VCR is so equipped (see page 6 or 36 for suitable inputs to the Scart socket on this TV.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCR on programme position ‘0’ of the TV. Either adjust the tuning of the TV’s programme position ‘0’ (follow the instructions below) or adjust the RF channel of your VCR (some VCRs allow adjustment of their RF channel via their remote control unit) or both until the TV receives the RF output channel of your VCR. It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Tuning your TV to the VCR.
Switch on the VCR, insert and play a
| 1 |
PICTURE | 2 |
| |
SOUND |
|
SET UP | 3 |
| TV/AV |
SET UP
Press 
.
Move to chosen Tuning menu option by using 
or 
.
Access Tuning menu by using 
or 
.
VCR CH44
4
5
6
Move to chosen Manual tuning by using 
or 
.
Access Manual tuning by using 
or 
.
Select programme position ‘0’ VCR by using 
or 
.
Manual tuning
7
Start searching for the VCR playback of the known content tape by using 
or 
.
2168
STR
When the VCR playback is found, pressing 
to store.
TV/AV
Pressing 
to exit.
VCR
The tape with known content is
found and displayed.
STR
Pressing 
will store the setting.
Notes:
•If picture patterning occurs on programme position ‘0’ it may be necessary to adjust the RF output channel of the VCR, refer to the VCR instruction book.
•If a Satellite Receiver and a VCR are going to be used with RF cable connections it is important to avoid both units being set on the same channel.
Refer to the Satellite Receiver and VCR instruction books for precise tuning information.
31