Panasonic TX-22LT2 manual Quick start Guide Connecting the AC Adaptor, Switch TV on, Auto set up

Quick start Guide

2. Connecting the AC Adaptor

	First, ensure that the VCR is in Stand-by mode.
	1 Connect the mains lead to the AC Adaptor.
3	2 Connect the AC Adaptor DC plug to the DC IN socket.
1	3 Plug into household mains socket.
	• Be sure to use the power cord and AC
	adaptor included in the accessories.
	• Do not use the AC adaptor for other than
	the specified equipment.
	• Unplug the AC adaptor if it is not used for
	long time.
	• Do not place any objects on the AC adaptor.
	• Do not use the AC adaptor outdoors.
	• Do not attempt to repair the AC adaptor if it
2	is broken or malfunctioning. Refer the
	servicing to the service representative.
	• Do not try to open the AC adaptor.
	• Do not use water or wet cloth for cleaning
	the AC adaptor.

3. Switch TV ON

Power-Indicator

The RED LED when lit indicates that not only the TV set is in stand-by mode but also the external AC adaptor is still on.

4. Auto set up

Press the switch on the LCD TV to turn the set on.

IMPORTANT NOTES

There are two ways to switch the TV set to stand-by mode.

(A)Press the switch on the LCD TV and check RED LED is lit.

OR

(B)Press the Stand-by button on the remote control.

The TV set cannot be switched on by the remote controller if it was switched to stand-by using method (A) or vice versa if method (B) was used.

When programme number up ()/down () buttons on the side panel of the main part are pressed in stand-by mode, TV turns on.

AUTO SETUP IN PROGRESS SEARCHING:PLEASE WAIT

2168

SETUP : Return to tuning menu

TV/AV : To exit

Programmes will appear immediately if your dealer has programmed the TV for you.

If the TV has not been programmed for you then Auto setup will begin, your stations will be located, sorted into order and stored ready for use.

9