Panasonic TH-P65VT30T, TH-P65VT30P Available range for the 3D Eyewear, To view the 3D images

Available range for the 3D Eyewear

If the 3D Eyewear is placed outside the available area for about 5 minutes, the 3D Eyewear will be turned off automatically.

: Available area to use the 3D Eyewear

Approx.			Approx.
	35°	35°
3.2 m			3.2 m

Approx. 3.2 m

Approx.	20°
	20°
3.2 m

View from the top View from the side

Note

•The range may be shortened depending on the obstacles between the infrared sensors on the TV and the 3D Eyewear, the dirt of the infrared sensors or the surrounding environment.

•If you do not look toward the TV screen for a while when viewing 3D images, the 3D Eyewear may be turned off automatically even if in the available area.

To view the 3D images

You can watch 3D images in the following cases:

•When a 3D image supporting Blu-ray Disc is played on a 3D image supporting player/recorder connected using a HDMI cable to a 3D image supporting television.

•3D image supported broadcast (programme)

•3D Photo, 3D Movie taken by LUMIX/Camcorder.

•2D→3D (Converts 2D images into 3D) “Change the view 3D ↔ 2D” (p. 30)

To view the contents or programmes

1Set the power switch to “ON”

(The indicator lamp will light for approximately 2 seconds, then flash once approximately every 2 seconds.)

2Put on the 3D Eyewear

3Watch the 3D images

When the HDMI receives information in which 3D mode is detected, 3D images are automatically displayed according to the signal.

If the 3D images are not displayed correctly or the images cause discomfort, the images can be adjusted by [3D Mode Selection] or [3D Settings].

“Change the view 3D ↔ 2D”, “[3D Settings] (Adjust 3D images)” (p. 30, 31)

■After Use

1Set the 3D Eyewear power switch to “OFF”

(The 3D Eyewear indicator lamp turns off, and the power turns off.)

2After using the 3D Eyewear, store it in the case provided

Viewing 3D images

29