Panasonic TC-P60ST60 AC Power Supply Cord, Radio waves, Handling the power supply cord

Page 5

Do not place the Plasma TV or its stand on a sloped or unstable surface.

The Plasma TV may fall or tip over.

Do not support the Plasma TV on a non- specified pedestal.

Do not place the Plasma TV on furniture that can easily be used as steps, such as a chest of drawers.

Do not climb or allow children to climb on the Plasma TV

Place or install the Plasma TV where it cannot be pushed, pulled over or knocked down.

Route all cords and cables such that they cannot be tripped over or pulled by curious children.

Do not place any objects on top of the Plasma TV. If water spills onto the Plasma TV or foreign objects get inside it, a short-circuit may occur, which could result in fire or electric shock. If any foreign objects get inside the Plasma TV, please consult an Authorized Service Center.

In the unlikely event that you receive a shock from this product, it is possible that your household outlet may be wired improperly. Have an electrician verify that the TV’s outlet is properly wired. If the symptom persists, have the TV serviced by a qualified authorized technician.

To prevent the spread of fire, keep candles or other open flames away from this product at all times

AC Power Supply Cord

To prevent fire or electric shock:

The Plasma TV is designed to operate on a 120 V AC, 60 Hz service. Insert the power cord plug as far as it will go into the wall socket.

If the plug is not fully inserted, heat may generate, which could cause a fire.

The included power cord is for use with this unit only.

Do not use any power cord other than that provided with this TV.

Do not handle the power cord plug with wet hands.

Do not do anything that might damage the power supply cord.

When disconnecting the power supply cord, hold the plug, not the cord.

Do not use the power supply cord if the plug or cord is damaged.

Replace the cord or contact your Authorized Service Center.

Do not use a 3-prong to 2-prong AC plug adapters to connect your TV’s plug to the wall outlet. Doing so will defeat the TV plug’s safety feature, which can lead to a shock hazard. If the wall outlet does not accommodate a 3-prong plug, have a qualified electrician replace your outlet and check the associated wiring.

If water or an object gets inside the Plasma TV, if the Plasma TV is dropped, or if the enclosure becomes damaged, unplug the power supply cord immediately. A short-circuit may occur, which could cause a fire. Contact an Authorized Service Center for an evaluation.

Radio waves

Do not place this TV in any medical institutions or locations with medical devices.

Radio waves from this TV may interfere with the medical devices and cause accidents due to the malfunction.

Do not use this TV near any automatic control

devices such as automatic doors or fire alarms. Radio waves from this TV may interfere with the automatic control devices and cause accidents due to the malfunction.

Keep this TV away at least 9 inches (22 cm) from the location where a cardiac pacemaker is implanted. Radio waves from this TV may interfere with the operation of the pacemaker.

Handling the power supply cord

Insert the power plug fully into the socket outlet. (If the power plug is loose, it could generate heat and cause fire.)

Ensure that the power plug is easily accessible.

Ensure the earth pin on the power plug is securely connected to prevent electrical shock.

• An apparatus with CLASS I construction shall be connected to a power socket outlet with a protective earthing connection.

Do not touch the power plug with a wet hand. (This may cause electrical shock.)

Do not use any power cord other than that provided with this TV. (This may cause fire or electrical shock.)

Do not damage the power cord. (A damaged cord may cause fire or electrical shock.)

• Do not move the TV with the cord plugged in the socket outlet.

• Do not place a heavy object on the cord or place the cord near a high-temperature object.

• Do not twist the cord, bend it excessively, or stretch it.

• Do not pull on the cord. Hold onto the power plug body when disconnecting cord.

• Do not use a damaged power plug or socket outlet.

If a problem occurs (such as no picture or no sound), or if smoke or an abnormal odor is detected from the Plasma TV, unplug the power supply cord immediately.

Continued use of the TV under these conditions might cause a fire or permanent damage to the TV. Have the TV evaluated by an Authorized Service Center. Servicing of the TV by unauthorized personnel is strongly discouraged due to its high voltage.

5

Image 5
Contents Viera English EspañolHttp//SCN.BY Do not display a still picture for a long time Set upTypical still images This product incorporates the following softwareContents Important Safety Instructions Safety PrecautionsHandling the power supply cord AC Power Supply CordRadio waves To prevent fire or electric shockDisassembly When Moving the Plasma TVAbout lithium battery Accidental IngestionCheck that the Access point supports WPS*2 About built-in wireless LAN/BluetoothFCC and IC Statement FCC CautionCEA Child Safety Notices Optional Accessories Accessories/Optional AccessoriesAccessories Page Assembly screws black Neck Assembly screws black BracketAttaching the pedestal to TV Removing the pedestal from the TVDamage to the remote control Installing the remote’s batteriesLeakage and corrosion, resulting Do not burn or break batteriesBack of the TV ConnectionsConnection Panels Or Cable TV Antenna or Cable connectionTo attach VHF/UHF AntennaAV Equipment Blu-ray Disc player AV cable connectionAV Equipment G. Blu-ray Disc player AV EquipmentOptical cable Audio connectionCable Binding Instructions Power indicator on red, off no light TV controls/indicatorsIdentifying Controls Front of the TVAccesses Netflix service directly Remote controlConfigure Network connection First Time SetupANT/Cable setup Adjust the ClockFor operations of each feature and the setup of Apps To access each featureOperations Watching TVDisplay the menu related to the explanation Using eHELP Built-in ManualJump to menu item Using radio waves Using PrecautionsViewing 3D images on TV LensChange the view 3D⇔2D RegistrationViewing 3D images Questions Frequently Asked Questions FAQAnswers How can I confirm that my TV is working properly?Care and Cleaning Specifications Security Frequency Range *1, *2Standard Compliance Frequency RangeOn-Site or Carry-In Service Limited Warranty CoverageLimited Warranty Limits And Exclusions Mail-In ServiceCustomer Services Directory United States and Puerto Rico Customer Services Directory for U.S.A. and Puerto RicoAccessory Purchases United States and Puerto Rico Panasonic National Parts CenterViera TV 46 & over In-home service Limited Warranty for CanadaViera TV under Carry-in service One 1 year, parts including panel and labourPage Anotación del cliente Customer’s RecordModelo Número de serie Ambler Drive