FAQs
Screen
Sound
HDMI
Other
Problem | Actions | |
| ● Change the setting of | |
Chaotic image, noisy | remove noise) (p. 23). | |
● Check nearby electrical products (car, motorcycle, | ||
| fluorescent lamp). | |
No image can be displayed | ● Is “Colour” or “Contrast” in the Picture Menu set to the | |
| minimum? (p. 23) | |
Blurry or distorted image | ● Reset channels (p. 28). | |
(no sound or low volume) |
| |
Unusual image is displayed | ● Turn off the TV with Mains power On / Off switch, then turn | |
| it on again. | |
No sound is produced | ● Is “Sound Mute” active? (p. 10) | |
● Is the volume set to the minimum? | ||
Sound level is low | ● Sound signal reception may be deteriorated. | |
or sound is distorted | ● Set “MPX” in the Sound Menu to “Mono” (p. 24). | |
Unusual sound from the | ● When power is on, drive noise may be heard from inside the | |
display unit | display unit (not a sign of faulty operation). | |
| ● Set the sound setting of the connected equipment to “2ch | |
| L.PCM”. | |
Sound is unusual | ● Check the “HDMI1 / 2 / 3 Input” setting in the Sound Menu | |
(p. 24). | ||
| ● If digital sound connection has a problem, select analogue | |
| sound connection (p. 42). | |
Pictures from external | ● Is the HDMI cable connected properly? (p. 34, 38, 39) | |
equipment are unusual | ● Turn Off the TV and equipment, then turn them On again. | |
when the equipment is | ● Check an input signal from the equipment (p. 43). | |
connected via HDMI | ● Use an equipment compliant with | |
TV goes into Standby | ● Auto power standby function is activated. | |
● The TV enters Standby mode about 30 mins. after | ||
mode | broadcasting ends. | |
| ||
| ● Are the batteries installed correctly? (p. 3) | |
| ● Has the TV been switched On? | |
The remote control does | ● Point the remote control directly at the front of the TV (within | |
a 30 degree angle of the front of the TV). | ||
not work or is intermittent | ||
● Situate the TV away from sunshine or other sources of | ||
| bright light not to shine on the TV’s remote control signal | |
| receiver. |
●Even when the temperature of parts of the front, top and rear Parts of the TV become hot panels has risen, these temperature rises will not pose any
problems in terms of performance or quality.
46