Panasonic TC-P60VT60, TC-P55VT60 FCC and IC STATEMENT, About built-in wireless LAN/Bluetooth

Page 7
FCC and IC STATEMENT

FCC and IC STATEMENT

This equipment has been tested and found to comply with the limits for an Other Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the Panasonic Service Center or an experienced radio/TV technician for help.

FCC Caution:

To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of North America could void the user’s authority to operate this device.

FCC and Industry Canada (IC) RF Exposure Warning :

This TV is provided with two built-in transmitters: (1) Wireless LAN Adapter with FCC ID:H8N-WLU5150/ IC ID:1353A-WLU5150; and (2) Bluetooth Adapter with FCC ID:NKR-P705/IC ID:4441A-P705.

These transmitters comply with FCC and IC radiation exposure limits set forth for an uncontrolled environment for mobile use with minimum 8 inches (20 cm) spacing requirement between transmitters and all person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.

This TV may also be provided with : (1) 3D Eyewear approved under FCC ID: OHP-SIRIUS / IC ID:7702B-

SIRIUS (2) VIERA Touch Pad Controller approved under FCC ID: MG3-0602284 / IC ID:2575A-0602284.

Other third-party wireless transmitters should not be used as they have not been RF exposure evaluated for use with this TV and may not comply with RF exposure requirements.

<Only for wireless LAN if capable of transmission in the 5.15 ~ 5.25 GHz frequency band> This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.

FCC and IC require this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this product.

Responsible Party:

Panasonic Corporation of North America

 

One Panasonic Way, Secaucus, NJ 07094

Contact Source:

Panasonic Consumer Marketing Company of North

 

America

 

1-877-95-VIERA (958-4372)

email:

consumerproducts@panasonic.com

This device complies with Part 15 of the FCC Rules and all applicable IC RSS standards. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

About built-in wireless LAN/Bluetooth

To use the built-in wireless LAN, using an access point is recommended.

To use the built-in wireless LAN in the access point mode, up to 7 devices are connectable. But the transfer rate will vary according to communication environment or connected equipments.

Do not use the built-in wireless LAN to connect to any wireless network (SSID*1) for which you do not have usage rights. Such networks may be listed as a result of searches. However, using them may be regarded as illegal access.

Check that the Access point supports WPS*2.

(If it does not support WPS, the encryption key of the Access point is required when configuring settings.) Follow the instructions on the Access point setup screen and configure the appropriate security settings.

For more details on setting of Access point, please refer to operating manual for the Access point.

We recommend using 11n (5 GHz) for the wireless system between the built-in wireless LAN and Access point. Communication is also possible with 11a, 11b, and 11g, but the communication speed may be slower.

If the wireless system of the Access point is changed, devices that could connect by wireless LAN may no longer be able to connect.

Data transmitted and received over radio waves may be intercepted and monitored. Keep the TV away from the following devices as much as possible:

Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such as malfunction may occur due to the radio wave interference.

When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In this case, turn the TV Off with power On / Off switch, then turn it On again.

*1 SSID is a name for identifying a particular wireless network for transmission. *2 WPS: Wi-Fi Protected Setup

7

Image 7
Contents English Español 55”/60”/65” Class 1080p Plasma HDTVTelevisión de alta definición de 1080p y clase 55”/60”/65” de Plasma Register online atDo not display a still picture for a long time Set upTypical still images Contents Please read before using the unitWARNING/CAUTION TV set Safety PrecautionsImportant Safety Instructions RISK OF ELECTRIC SHOCK DO NOT OPENTo prevent fire or electric shock AC Power Supply CordHandling the power supply cord Radio wavesWARNING/CAUTION 3D Eyewear When Moving the Plasma TVDisassembly About lithium batteryFCC and IC STATEMENT About built-in wireless LAN/BluetoothTUNE INTO SAFETY CEA CHILD SAFETY NOTICESCheck that all the following items have been included with your TV Accessories/Optional AccessoriesAccessories Optional AccessoriesPage Assembly screws Attaching the pedestal to TVM5 × M4 ×Remote Control Installing the remote’s batteriesVIERA Touch Pad Controller Connection Panels ConnectionsBack of the TV VHF/UHF Antenna Antenna or Cable connectionPower Cord Connect after all other connections have been made To attachTo use COMPOSITE terminals BestTo use HDMI terminals GoodCable Binding Instructions Audio connectionIdentifying Controls TV controls/indicatorsFront of the TV Switches TV On or Off Standby Displays 3D settings VIERA Touch Pad Controller Pairing Touch Pad ControllerParts names and functions Operating Touch Pad ControllerSelect type of Home Screen First Time SetupTurn the TV on with the POWER button Setup the following itemsOperations Turn power onAccess “Apps list” and select a feature To access each featureJump to menu item Using eHELP Built-in ManualDisplay eHELP Select the desired page from the menuLens Using PrecautionsUsing radio waves Viewing 3D images on TVTurn off the 3D Eyewear Simply switches 3D ⇔ 2D images Auto modeTurn the 3D Eyewear on and put it on ViewWhy is the screen blank and the power indicator blinking? Frequently Asked Questions FAQWhy doesn’t the remote control work? Why doesn’t the Touch Pad Controller work?Display panel Care and CleaningFirst, unplug the power cord plug from the wall outlet Power cord plugFocus SpecificationsResolution LensStandard Compliance BatteryFrequency Range *1, *2 SecurityOn-Site or Carry-In Service Limited Warranty for U.S.A. and Puerto Rico onlyPanasonic Television Limited Warranty Limited Warranty Coveragenpcparts@us.panasonic.com Customer Services Directory for U.S.A. and Puerto RicoCustomer Services Directory United States and Puerto Rico Accessory Purchases United States and Puerto RicoPanasonic Canada Inc Limited Warranty for CanadaPANASONIC PRODUCT - LIMITED WARRANTY WARRANTY SERVICEPage Page Anotación del cliente or callo llame al Customer’s Record