PC Input Terminals Connection
Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
Some PC models cannot be connected to the set.
There is no need to use an adapter for computers with IBM PC/AT compatible
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. Signal Names for
|
|
|
| Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name |
11 | 12 | 13 | 14 | 15 | R |
| GND (Ground) |
| NC (not connected) |
6 | 7 | 8 | 9 10 | G |
| GND (Ground) |
| NC | |
1 | 2 | 3 | 4 | 5 | B |
| GND (Ground) |
| HD/SYNC |
|
|
|
|
| NC (not connected) |
| NC (not connected) |
| VD |
Pin Layout for PC Input Terminal | GND (Ground) |
| GND (Ground) |
| NC | ||||
|
|
|
|
| |||||
Care and Cleaning
First, unplug the Power cord plug from the wall outlet.
Display panel
The front of the display panel has been specially treated. Wipe the panel surface gently using only a cleaning cloth or a soft, lint- free cloth.
If the surface is particularly dirty, soak a soft,
Do not scratch or hit the surface of the panel with fingernails or other hard objects. Furthermore, avoid contact with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the surface may be adversely affected.
Cabinet
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
If the cabinet is particularly dirty, soak the cloth in a weak mild liquid dish soap and then wring the cloth dry. Use this cloth to wipe the cabinet and then wipe it dry with a dry cloth.
Do not allow any mild liquid dish soap to come into direct contact with the surface of the Plasma TV. If water droplets get inside the unit, operating problems may result.
Avoid contact with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the cabinet surface may be adversely affected or the coating may peel off. Furthermore, do not leave it for long periods in contact with articles made from rubber or PVC.
Pedestal
Cleaning
Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to which a small amount of mild liquid dish soap has been added and then wipe with a dry cloth.
Do not use products such as solvents, thinner, or household wax for cleaning, as they can damage the surface coating. (If using a
Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty. Do not allow
Care and Cleaning FAQs, etc. Technical Information
61