FCC STATEMENT
This equipment has been tested and found to comply with the limits for an Other Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the Panasonic Service Center or an experienced radio/TV technician for help.
FCC Caution:
To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of North America could void the user’s authority to operate this device.
Responsible Party: | Panasonic Corporation of North America |
| One Panasonic Way, Secaucus, NJ 07094 |
Contact Source: | Panasonic Consumer Electronics Company |
| |
email: | consumerproducts@panasonic.com |
CANADIAN NOTICE:
For Model
This Class B digital apparatus complies with Canadian
Notes
Do not display a still picture for a long time
This causes the image to remain on the plasma screen
(“Image retention”). This is not considered a malfunction and is not covered by the warranty.
4 : 3
12 |
To prevent the “Image retention”, the screen saver is automatically activated after a few minutes if no signals are sent or no operations are performed. (p. 49)
Typical still images |
| |
• Channel number and other logos |
| |
• Image displayed in 4:3 mode | • Computer image | |
• SD Card photo | • Video game | |
Set up
Do not place the unit where it’s exposed to sunlight or other bright light (including reflections).
Use of some types of fluorescent lighting may reduce the remote control’s transmission range.
7