
FAQs
Problem | Actions |
|
|
Screen
| Set | ||
Chaotic image, noisy | Check nearby electrical products | ||
| (car, motorcycle, fluorescent lamp). | ||
|
|
| |
| Is “Colour” or “Contrast” in the Picture Menu set to | ||
No image can be | the minimum? (p. 20) | ||
displayed | Check Colour System. (p. 27) | ||
| Check AV Colour System. (p. 21) | ||
|
|
| |
Blurry or distorted image | Reset channel. (p. 28) | ||
(no sound or low volume) | |||
|
|
Unusual image is displayed | Turn off the TV with Mains power On / Off switch, | |
then turn it on again. | ||
|
Sound
HDMI
No sound is produced | Is “Sound mute” active? (p. 8) | ||
Is the volume set to the minimum? | |||
| |||
|
|
| |
Sound level is low | Sound signal reception may be deteriorated. | ||
Check Sound system. (p. 27) | |||
or sound is distorted | |||
Set “MPX” (p. 20) in the Sound Menu to “Mono”. | |||
| |||
|
|
| |
| Set the sound setting of the connected equipment to | ||
| “2ch L.PCM”. | ||
Sound is unusual | Check the “HDMI1 Input” (or “HDMI Input” for | ||
| |||
| If digital sound connection has a problem, select | ||
| analogue sound connection. (p. 43) | ||
|
|
| |
Pictures from external | Is the HDMI cable connected properly? (p. 45) | ||
Turn Off the TV and equipment, then turn them On | |||
equipment are unusual | |||
again. | |||
when the equipment is | |||
Check an input signal from the equipment. (p. 46) | |||
connected via HDMI | |||
Use an equipment compliant with | |||
|
Other
TV goes into “Standby mode”
The remote control does not work
Off Timer function is activated.
The TV enters “Standby mode” about 30 min. after broadcasting ends.
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
Has the battery run down?
48