Panasonic TH 65PZ850U quick start Select Connection test and press OK

Check that the network settings are as shown below, and then start “Connection test”.

Select “Connection test” and press OK.

*Press OK again to cancel the test. (It takes a while to cancel the test.)

Network setting	1/2	select
Connection test	Succeeded
IP setting mode	Manual	ok
IP address	192.168.0.5
Sub netmask	255.255.255.0
Default gateway	192.168.0.254

Succeeded: “Connection test” succeeded

Failed: Check the broadband environment connection and settings and the network settings, and then perform the test again.

Test in progress

---: Test not yet performed

Select “IP setting mode” and set to “Automatic”.

(When IP automatic acquisition in DHCP can be used)

Network setting		1/2	select
Connection test	Succeeded
IP setting mode	Automatic
IP address	192.168.0.5		ok
Sub netmask	255.255.255.0
Default gateway	192.168.0.254

■Manual setting

Select “IP setting mode” and set to “Manual”

Select the item and press OK

Check the specifications of the broadband router and enter each IP address.

Sub netmask
	10I

The acquired address is displayed.	or	change
Each IP address is acquired automatically.
		channel
		ok

Select “DNS setting mode” and set to “Automatic”. ■Manual setting

	(When DNS automatic acquisition in DHCP can be used)			Select “DNS setting mode” and set to “Manual”
	Network setting	2/2	select	Select the item and press OK
				Enter each IP address as was specified by the
	DNS setting mode	Automatic
				provider.
	Primary DNS	192.168.0.20	ok
	Secondary DNS	192.168.0.21
				Primary DNS
	LAN d tti	M l			10I
The acquired address is displayed.

Each IP address is acquired automatically.

If you are using a broadband router, IP automatic	or	select
acquisition in DHCP can be used under normal		ok
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions for each device.

Network Setting

Advanced

Select “LAN speed setting” (Default is “Automatic”)

Network setting	2/2	select
DNS setting mode	Automatic
Primary DNS	192.168.0.20	adjust
Secondary DNS	192.168.0.21
LAN speed setting	Automatic
LAN speed	10BASE half duplex

Normally, select “Automatic”.

If “Connection test” failed, set the “LAN speed setting” to “manual” and then select “10BASE half duplex”, “10BASE duplex”, “100BASE half duplex” or “100 BASE duplex”.

Cannot be selected when the “LAN speed setting” is “Automatic”.

Changing the settings may make it impossible to connect some types of equipment.

Select “Software update”			Press OK to start the software update screen.
		select	Follow directions of the screen.
Network setting	2/2
DNS setting mode	Automatic		* Set “Clock” first. (p. 15)
Primary DNS	192.168.0.20	ok
Secondary DNS	192.168.0.21
LAN speed setting	Automatic
LAN speed	10BASE half duplex
Software update

The network settings become effective when you close the menu and run “Connection test”. 37