Panasonic TH 50VX100U manual Input signal display, Setting RGB sync signal, Auto on G VBS, OFF on

SET UP for Input Signals

SYNC

Select SIGNAL from the “SET UP” menu during RGB input signal.

SIGNAL	[ RGB ]
SYNC	AUTO
XGA MODE	1024 ×768
REFRESH RATE	100 Hz

2 change 1 select

AUTO ON G VBS

Setting RGB sync signal

Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT signal)

AUTO: The H and V sync or synchronized signal are automatically selected. If both input, it is selected the H and V sync.

ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.

VBS: Uses a synchronized signal of Composite Sync input, which is input from the HD connector.

SDI THROUGH

Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).

Note:

Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD) is selected.

SIGNAL	[ Digital ]
SDI THROUGH	OFF
REFRESH RATE	100 Hz

2 change

1 select

OFF ON

ON: Enables active through.

OFF: Disables active through.

Input signal display

Displays the frequency and the type of the current input signal.

This display is valid only for COMPONENT/RGB/PC and Digital input signal.

Display range:
Horizontal	15	- 110 kHz
Vertical	48	- 120 Hz

The dot clock frequency is displayed during digital signal input.

H-FREQ.	33.7	kHz
V-FREQ.	60.0	Hz
SIGNAL FORMAT	1125(1080)/60i
H-FREQ.	33.7	kHz
V-FREQ.	60.0	Hz
DOT CLOCK-FREQ.	108.0	MHz
SIGNAL FORMAT	1125(1080)/60i

41