Connections
When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation. (Example:
Speakers (Optional accessories)
SPEAKERS | AC cord connection |
Terminals (R) | (see page 12) |
| – AC cord fixing |
SPEAKERS Terminals (L)
1 |
|
2 | 1 |
| |
| 2 |
1.Open the clamper.
Clamper
2. Insert the AC cord and close the clamper securely.
AC cord
3.Slide up the clamper and fix the AC cord plug securely.
When loosen the clamper:
4.Insert the point of the fixed clamper into the small hole on the lower
r i g h t o f the back cover as necessary.
Note: The power plug in the illustration may not be the type fitted to your set.
– Cable fixing bands Secure any excess cables with bands as required.
Pass the attached cable fixing band through the clip as shown in the figure.
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
1
2
To tighten: | To loosen: |
Push the catch Pull
Pull
R AUDIO L | VIDEO IN VIDEO OUT |
IN |
|
S VIDEO IN | AV |
SLOT1
AUDIO
SLOT2 | SLOT3 | PC IN |
|
SERIAL
|
|
|
|
|
|
AV Terminals |
| Optional Terminal |
| Optional Terminal | |
(see page 11) |
| Board Insert Slot |
| Board Insert Slot | |
|
| (covered) |
| (covered) | |
|
Notes:
•At factory shipment, Terminal board is installed in SLOT 1 only.
•
From EXTERNAL monitor terminal on Computer (see page 9)
From SERIAL Terminal on Computer
(see page 10)
8