Panasonic TH-50PV700AZ Chaotic image, noisy No image can be, Displayed, Blurry or distorted image

FAQs

Problem

Chaotic image, noisy

	No image can be
Screen	displayed
	Blurry or distorted image
	(no sound or low volume)

Actions

•Set “P-NR” in the Picture Menu (to remove noise). (p. 20)

•Check nearby electrical products (car, motorcycle, fluorescent lamp).

•Is(p.“Colour”20) or “Contrast” in the Picture Menu set to the minimum?

•Check Colour system. (p. 23)

•Reset channels. (p. 23)

Unusual image is displayed •again.Turn off the TV with Mains power On / Off switch, then turn it on

No sound is produced

Sound	Sound level is low
	or sound is distorted

Sound is unusual

HDMI

Pictures from external equipment are unusual when the equipment is connected via HDMI

TV goes into “Standby mode” Other The remote control

does not work

•Is “Sound mute” active? (p. 7)

•Is the volume set to the minimum?

•Sound signal reception may be deteriorated.

•Check Sound system. (p. 23)

•Set the sound setting of the connected equipment to “2ch L.PCM”.

•Check the “HDMI1 / 3 Input” setting in the Sound Menu. (p. 20)

•If digital sound connection has a problem, select analogue sound connection. (p. 37)

•Is the HDMI cable connected properly? (p. 32)

•Turn Off the TV and equipment, then turn them On again.

•Check an input signal from the equipment. (p. 38)

•Use an equipment compliant with EIA/CEA-861/861B.

•Off Timer function is activated.

•Theends.TV enters “Standby mode” about 30 min. after broadcasting

•Are the batteries installed correctly? (p. 6)

•Has the TV been switched On?

40