Panasonic TH-42PW4 PC Input connection, Signal Names for D-sub 15P Connector, Sda Hd/Sync Scl

Connections

PC Input connection

COMPUTER

AUDIO

PC IN

	Conversion adapter (if necessary)	D-sub 15p
	RGB
	PC cable
	Ferrite core	Less than
	(supplied)
		7" 7/8
		(20 cm)
	Audio
		1/8" (3mm) stereo plug
	Connect a cable which matches
	the audio output terminal on the computer.
Installing the ferrite core
1	2	3
	Open

Pull back the tabs	Press the cable
	through and close
(in two places)

Notes:

(1)Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed if signals exceeding 1200 lines will not be displayed properly.)

(2)The display resolution is a maximum of 640 ⋅ 480 dots when the aspect mode is set to “NORMAL”, and 852 ⋅ 480 dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.

(3)The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection.

(4)Some PC models cannot be connected to the set.

(5)There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.

(6)The computer shown in the illustration is for example purposes only.

(7)Additional equipment and cables shown are not supplied with this set.

(8)Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.

Signal Names for D-sub 15P Connector

11 12 13 14 15

6 7 8 9 10

1 2 3 4 5

Pin layout for PC input terminal

Pin No. Signal Name

1R

2G

3B

4GND (Ground)

5GND (Ground)

Pin No.	Signal Name	Pin No.
6	GND (Ground)	11
7	GND (Ground)	12
8	GND (Ground)	13
9	NC (not connected)	14
10	GND (Ground)	15

Signal Name

GND (Ground)

SDA

HD/SYNC

VD

SCL

16