Panasonic 58PF12UK operating instructions Connections, AC cord fixing, Cable fixing band

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.

Speakers (Optional accessories)

Speaker

terminal (L)

Speaker
		AC cord connection (see page 12)
terminal (R)
	– AC cord fixing

1	1 Plug the AC cord into	Close
	the display unit.	Push until
	Plug the AC cord until it
		the hook
	clicks.	clicks.

	2 Fix the AC cord with the clamper
2	which is attached to the unit.	Open
Note:	For TH-58PF12UK:	2.	Pull off.
	Clampers are not installed to this
Make sure that the AC	unit. Ensure there is sufficient slack	1.	Keep the
cord is locked on both	in the AC cord and firmly bind with		knob
the left and right sides.	the supplied cable fixing band, etc.		pressed.

1
2	1
	2

Unplug the AC cord

Unplug the AC cord pressing the two knobs.

Note:

When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.

–Cable fixing band

Secure any excess cables with band as required.

Note:

One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.

Pass the attached cable fixing band through the clip as shown in the figure.

1

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:	To loosen:
	Push the catch
Pull
2	Pull

	R AUDIO	L	PR/CR/R PB/CB/B	Y/G		AUDIO
	COMPONENT/RGB IN
SLOT1	SLOT2		SLOT3	PC	IN	SERIAL

Optional Terminal Board Insert Slot (covered)

Dual HDMI Terminals (equivalent of Dual HDMI Terminal Board (TY- FB10HMD)) (see page 11)

COMPONENT/RGB IN andAudio IN Terminals (equivalent of BNC Component Video Terminal Board (TY-42TM6A)) (see page 11)

From EXTERNAL monitor terminal on Computer (see page 9)

From SERIAL Terminal on Computer (see page 10)

Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

8