Panasonic PT 52DL10 Remote Control Battery Installation, Precaution on battery use

Installation

Remote Control Battery Installation

Requires two AA batteries (supplied).

1.Turn the Transmitter face down. Remove top cover by pressing down on marking and sliding cover off in the direction indicated.

2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment).

3.Replace the cover and slide in reverse until the lock snaps.

Two AA size

Helpful Hint:

For frequent remote control users, replace old batteries with Alkaline batteries for longer life.

Note: In order to maximize the life of the batteries, the lighted buttons on the Remote Control can be turned OFF and ON by pressing R-TUNE and RECALL at the same time.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precautions:

1.Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when the remote control acts sporadically or stops operating the projection TV set.

Helpful Hint:

Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on page 64, prior to setting up the remote.

7