Panasonic TX-76DT30A manual Rear Panel Connections, Important Notes

Rear Panel Connections

Common Interface Module (This feature is not currently in use in Australia).

The Common Interface Module menu provides access to software contained on Common Interface Modules. These can be inserted in the "CI1" and "CI2" slots located at the rear of the TV.

IMPORTANT NOTES:

Switch off the TV using the front panel switch before Inserting or removing a module.

If you are Installing a TV software update, please follow the dedicated Instructions supplied with the module.

Inserting a conventional Common Interface Module.

		AUDIO OUT
	SERIAL
CI 1 CI 2	MODEM	AV1	AV2	AV4

TO ACCESS COMMON

INTERFACE SLOTS PLEASE

REMOVE COVER

Switch on the TV

Open the Setup menu

Move to DVB setup

Access DVB setup menu

Move to Common Interface Module

Access Common Interface Module

Select the Module name

Some Common Interface Modules may be a two piece design consisting of a card reader together with the viewing card. When using this design of card, first insert the card reader firmly into a Cl slot on the TV (flap side to the left). Secondly, insert the viewing card into the

reader.	TV
Viewing card	Insert flap
	side to the
	left.
Card
reader
	Select
	Access
	Exit
Setup menu
DVB Timer programming
Off timer	Off
DVB timer lock	Off
DVB setup	Access
Teletext	Top
Flicker reduction	On
Geomagnetic
AV2 out	Analogue
Tuning menu

DVB - Setup

Signal quality

Common interface module Access

Favourites setup
Preferred subtitle	English
System update
Display timeout	3 seconds
PC Connection
Modem

Access the module

If no modules are inserted the message "No module inserted" will be displayed. (If you have inserted a module, check that it is fully inserted.)

DVB - Setup

Slot 1: No module inserted Access

Slot 2: No module inserted

The features that now appear on screen are dependent on the contents of the selected Common Interface Module. Refer to the instructions supplied with the card or contact the vendor.

In all cases, it is possible to navigate the pages using buttons on the remote control, but because the commands available must apply to all manufacturers of DVB equipment, some on-screen commands may not correspond exactly to the remote control buttons. For example:

For the on-screen command 'select' or 'go', use the OK button. If you see the A " B Y symbols, use the cursor keys.

If you see a line of key words displayed in red, green, yellow and blue, use the coloured multifunction buttons to operate the functions.

The EXIT button should always allow you to exit the Cl software.

42