Audio settings, Center delay, Bass | Kompernass KH 6516, KH 6515

None:

OFF:

ON:

PCM:

RAW:

OFF:

Attention!

In the event that you set an incorrect Video output, for example "P-Scan", although your television is not capable of Progressive Scan, then the tele- vision screen will suddenly become black.

This is not a defect of the television or the DVD player!

In this case press the STOP button on the front panel of the DVD player or on the remote control.

Then keep pressing the button "Video Out" on the remote control until the Image reappears on the television screen.

Brightness: Here, with the control buttons , you set the brightness value (1-16) of the DVD player.

Sharpness: Here, with the control buttons you set the sharpness value (1-16) of the DVD player.

HD Resolution: Here you can select from several resolutions for the HDMI output. Check, using the playback device's instruction manual, which resolutions (480p/576p/720p/1080i/Auto) are supported. In the Auto setting the resolution 720p is used.

HD-JPEG-Mode: Here you can select from several resolutions for the image display via the HDMI Output.

10.4 Audio settings

In this OSD menu you can administer the settings for the Bass management, the Box dimensions individual speakers, Test tones, Delays, digital Output, Night Mode and ProLogic.

Subwoofer: Set this entry to Present when a subwoofer is connected and is to be activated.

In order to deactivate this sound output set the entry to None.

Test tones: Here you can switch on a test sound for each particular audio output in order to check your 5.1 Surround settings.

Center delay,

Surr. delay: Here you set the delay for the centre and rear surround loud- speakers. Each increase of the distance setting corresponds to a delay of one millisecond. With optimal settings the sound reaches your ears simultaneously from all directions.

Center: No Delay, 0.3, 0.6, 1, 1.4, 1.7 m

Surround: No Delay, 1, 2, 3, 4 or 5.1 m

Digital Output: Here you set the DVD players digital output signal. no digital audio component connected

two channel digital audio component connected via co-axial cable or optical cable.

multi channel digital audio component, i.e. DTS receiver, connected via co-axial cable or optical cable.

Night Mode: Here you can activate/deactivate the night mode. This setting facilitates an optimal sound playback with reduced volume. The loud passages are suppressed and the quieter passages are played back a little louder. This function is only possible when using a digital audio component.

ProLogic:Here you set the Dolby ProLogic compatibility.

No Dolby Prologic compatible audio component is connected to the analogue stereo output (L/R). A Dolby Prologic compatible audio component is connected to the analogue stereo output (L/R) of the DVD player.

Bass

management: Here you can Activate/Deactivate the Bass-Management. Activation (On) is necessary if you are not using a 5.1 ampli- fier with its own speaker management but rather want the sound output transmitted via a particular amplifier. In this case the DVD player must be informed which kind of speaker (Small/Large) is to be run from the respective sound output. In this way the sound and the separation of Highs, Middles and Basses can be optimally conformed.

Front speakers, Center speaker, Surround speakers:

Note:

Here you can Activate/Deactivate the particular speaker type and set the size.

Large: Activate sound output for large speakers.

Small: Activate sound output for small speakers. (selectable only when Bass-Management is activated)

Deactivate sound output for these types of speakers

The entry Front speakers can not be deactivated since sound output for the front speakers is always switched on.

- 13 -