Magnavox 32MD350B user manual  Supplied Accessories,  Attaching the Stand

Page 6

INTRODUCTION

Supplied Accessories

user manual (1EMN25919)

quick start guide

remote control

registration card

For 37MD350B only

For 37MD350B

(NF801UD)

(1EMN24699)

AC power cord

(WAV0162LW001) or

(1EMN25960)

 

 

 

 

(WAV0162LTE03) or

For 32MD350B

 

 

 

 

(WAV152ZHN001)

(1EMN25920)

 

 

 

 

 

batteries

(AAA, 1.5V x 2)

AAA

screw kit for attaching the stand

AAA

For 37MD350B 3 screws (1ESA20208)

 

 

For 32MD350B 4 screws (1ESA19508)

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Note:

•For 32MD350B, nonremovable AC power cord is already fixed on the unit.

Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.

1 Spread a thick and soft cloth over a table as shown below.

Place the main unit face down onto it. Make sure not to damage the screen. At least 2 people are required at this step.

2 Align the 2 stand hooks with the two hooks under the bottom of the main unit (shown by arrow ➀), then slide the stand in the direction as shown by arrow ➁until it stops and the mounting holes are aligned.

For 32MD350B

Make sure not to put the AC power cord between the stand and the unit.

3 Drive Phillips pan screws in threaded holes at the bottom of the stand until they are tight.

➁

front

➀

side

 

To remove the stand from this unit

Unscrew the Phillips pan screws on step 3.

After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

6

EN

Page 5 Page 7
Image 6
Page 5 Page 7
Contents 37MD350B 32MD350B Returning the enclosed card Proof of PurchaseFor Customer Use Purchase will be on file, so noRead before operating equipment Introduction  PrecautionLaser Safety Important Copyright InformationTrademark Information  Symbols Used in this ManualWhen Carrying this Unit Location and Handling Supplied Accessories  Attaching the StandTo remove the stand from this unit  Features DTV/TV/CATVDVD Functions  ContentsTV Functions Paused and Step-by-step Playback Terminals Hdmi 3 Input jack p / pAnalog mode TV  Remote Control FunctionDigital mode DTV DVD mode Installing the Batteries Battery PrecautionsPreparation  Antenna Connection Connection to Cable Receiver or Satellite Box  External Device Connection Hdmi ConnectionHDMI-DVI Connection Component video Connection Video ConnectionSide of this unit Video cable Audio cable Stereo system Dolby Digital Decoder Audio Output ConnectionCamcorder Digital audio coaxial cablePC Connection ResolutionCable Management FormatBefore you begin TV Functions  Initial SetupAfter an initial setup is completed Make sure the unit is connected to antenna or cableWatching TV  Volume Adjustment Sleep Timer  Channel Selection Still Mode  Switching Each Input ModeSwitching Audio Mode Press Info  TV Screen InformationBroadcasting information Program title Program guideFor PC input signal through  TV Screen Display ModeFor 169 video signal Input modeOptional Setting Main MenuUse Cursor K/L to select Channel List, then press Again using CH + Channel List Press Menu to exit Antenna Confirmation  Language SelectionUse Cursor K/L to select Antenna, then press OK Use Cursor K/L to select the desired setting, then press OK  Picture AdjustmentAdjust the picture quality Smart PictureSmart Sound  Sound AdjustmentAuto Volume Leveling EqualizerCaption Service Caption mode Closed Caption Digital Caption Service To select Digital Caption ServiceUse Cursor K/L to select User Setting, then press Font Opacity Font SizeFont Color Background ColorChannel Lock US Movie ratings lock   Child LockUse Cursor K/L to select Child Lock, then press Change PINChannel Lock US Movie ratings lockAssociation of America US TV ratings lock To set the sub ratingsUse Cursor K/L to select US TV ratings lock, then press OK Change PIN Use Cursor K/L to select Change PIN, then pressPress Menu to display the main menu Adjust the setting  PC SettingsPosition Reset Use Cursor s/B to adjustUse Cursor K/L to select Energy Saving Mode, then press OK  Energy Saving ModeLocation Use Cursor K/L to select the desired mode, then press OKTo display the main menu To select FEATURES, then press Current Software Info Confirm the version of the software currently used Unplayable Media Perating DVDDVD Functions  Playable Media Inches 12 cm Disc Menu Operating DVD Playback  Resume Playback Slow Forward / Slow Reverse During playback, press Mode repeatedly until appears Fast Forward / Fast Reverse  ZoomChapter / Title / Track Search During playback, press Mode repeatedly until / appears Search Functions You can select chapters, titles or tracks on the discTime Search Direct SearchRepeat Playback Repeat A-B Playback Programmed Playback  Random PlaybackYou can repeat playback between a and B on a disc Special Settings  On-screen DisplayCursor K/ L repeatedly until your desired Camera Angles Black Level SettingPress Cursor K/ L to adjust the black level Audio LanguageRight channels Stereo Sound ModeVirtual Surround Left channel sound onlySubtitle *1, *2Default OFF DVD Setting DVD Language Setting Audio *1, *2Cursor K/ L to select DVD, then press OK  DVD Audio SettingDefault on Use Cursor K/ L to select the desired item, then press Parental Setting Number buttons to enter the current 4-digit passwordParental Level  Others You can change the other functions Reset to the Default Setting  Language Code List Use Cursor K/ L to select YES, then press OKTroubleshooting There is no clock function on this unitTroubleshooting  Troubleshooting GuideCaptions are displayed as a White box You switch to a different input and the volumeCheck the Parental setting Black box is displayed on the TV screen Glossary  MaintenanceInformation Ntsc Other Specifications  General Specifications Electrical Specification CatvLimited Warranty Ninety 90 DAY Labor / ONE 1 Year Parts Français
Top Page Image Contents