Magnavox 32MD350B user manual Preparation,  Antenna Connection

Page 12

PREPARATION

No supplied cables are used in this connection:

Please purchase the necessary cables at your local store.

High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility.

Before you connect...

Be sure your antenna or other device is connected properly before plugging in the AC power cord.

Antenna Connection

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF antenna

rear of this unit

RF coaxial cable

or

cable TV signal

*Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. Refer to “Initial Setup” on page 17.

Note:

If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than settop versions.

To switch your reception source easily between antenna and cable, install an antenna selector.

If you are not receiving a signal from your cable service, contact the Cable provider.

Connection to Cable Receiver or Satellite Box

Use an HDMI or an component video cable to connect the HDMI or the Component video Input jack of the unit to the HDMI or the component video output jack of the cable receiver / satellite box.

If you connect to the unit’s Component video Input jack, connect audio cables to the Audio L/R jacks below the Component video connector.

e.g.)

HDMI OUT

 

 

HDMI cable

 

satellite dish

or

 

 

 

 

 

 

 

 

or

 

AUDIO OUT

COMPONENT VIDEO OUT

 

L

R

Y

Pb/Cb Pr/Cr

 

ANT IN

or

RF coaxial

(green)

(blue)

(red)

(green)

cable

 

 

 

(blue)

 

 

 

 

 

 

 

 

 

 

(red)

cable TV signal

or

 

including PPV

STEREO

PCM

cable receiver / satellite box

37MD350B only

side or

rear of this unit

component video cable and audio cable

*You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jack because they might have different output jacks.

*Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable / satellite provider.

12

EN

Image 12
Contents 37MD350B 32MD350B Proof of Purchase For Customer UseReturning the enclosed card Purchase will be on file, so noRead before operating equipment  Precaution Laser SafetyIntroduction Important Copyright Information Symbols Used in this Manual When Carrying this UnitTrademark Information Location and Handling Supplied Accessories  Attaching the StandTo remove the stand from this unit  Features DTV/TV/CATV Contents TV FunctionsDVD Functions Paused and Step-by-step Playback  Terminals Hdmi 3 Input jack p / p Remote Control Function Digital mode DTVAnalog mode TV DVD mode Installing the Batteries Battery PrecautionsPreparation  Antenna Connection Connection to Cable Receiver or Satellite Box  External Device Connection Hdmi ConnectionHDMI-DVI Connection Component video Connection Video ConnectionSide of this unit Video cable Audio cable Audio Output Connection CamcorderStereo system Dolby Digital Decoder Digital audio coaxial cableResolution Cable ManagementPC Connection FormatTV Functions  Initial Setup After an initial setup is completedBefore you begin Make sure the unit is connected to antenna or cable Volume Adjustment  Sleep TimerWatching TV  Channel Selection Still Mode  Switching Each Input ModeSwitching Audio Mode  TV Screen Information Broadcasting informationPress Info Program title Program guide TV Screen Display Mode For 169 video signalFor PC input signal through Input modeOptional Setting Main MenuAgain using CH +  Channel ListUse Cursor K/L to select Channel List, then press Press Menu to exit Antenna Confirmation  Language SelectionUse Cursor K/L to select Antenna, then press OK  Picture Adjustment Adjust the picture qualityUse Cursor K/L to select the desired setting, then press OK Smart Picture Sound Adjustment Auto Volume LevelingSmart Sound EqualizerCaption Service Caption mode Closed Caption Digital Caption Service To select Digital Caption ServiceUse Cursor K/L to select User Setting, then press Font Size Font ColorFont Opacity Background Color Child Lock Use Cursor K/L to select Child Lock, then pressChannel Lock US Movie ratings lock  Change PINChannel Lock US Movie ratings lockAssociation of America US TV ratings lock To set the sub ratingsUse Cursor K/L to select US TV ratings lock, then press OK Change PIN Use Cursor K/L to select Change PIN, then press PC Settings Position ResetPress Menu to display the main menu Adjust the setting Use Cursor s/B to adjust Energy Saving Mode LocationUse Cursor K/L to select Energy Saving Mode, then press OK Use Cursor K/L to select the desired mode, then press OKTo select FEATURES, then press  Current Software InfoTo display the main menu Confirm the version of the software currently usedPerating DVD DVD Functions  Playable Media Unplayable Media Inches 12 cmOperating DVD  Playback Disc Menu  Resume PlaybackDuring playback, press Mode repeatedly until appears  Fast Forward / Fast Reverse Slow Forward / Slow Reverse  ZoomDuring playback, press Mode repeatedly until / appears  Search FunctionsChapter / Title / Track Search You can select chapters, titles or tracks on the discTime Search Direct SearchRepeat Playback Repeat A-B Playback Programmed Playback  Random PlaybackYou can repeat playback between a and B on a disc Special Settings  On-screen DisplayCursor K/ L repeatedly until your desired Black Level Setting Press Cursor K/ L to adjust the black levelCamera Angles Audio LanguageStereo Sound Mode Virtual SurroundRight channels Left channel sound onlyDVD Setting  DVD Language SettingSubtitle *1, *2Default OFF Audio *1, *2 DVD Audio Setting Default onCursor K/ L to select DVD, then press OK Use Cursor K/ L to select the desired item, then press Parental Setting Number buttons to enter the current 4-digit passwordParental Level  Others You can change the other functions Reset to the Default Setting  Language Code List Use Cursor K/ L to select YES, then press OKTroubleshooting There is no clock function on this unitTroubleshooting  Troubleshooting GuideYou switch to a different input and the volume Check the Parental settingCaptions are displayed as a White box Black box is displayed on the TV screen Maintenance Information Glossary Ntsc General Specifications  Electrical Specification Other Specifications CatvLimited Warranty Ninety 90 DAY Labor / ONE 1 Year Parts Français