Channel SET UP, Auto Channel Programming, Enter

CHANNEL SET UP

Make sure ...

•The unit must be turned on.

AUTO CHANNEL PROGRAMMING

As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory.

1 Select “CHANNEL SET UP”	- TV SETUP -
Press [SETUP].	B CHANNEL SET UP
Press [K/L] to point to	V-CHIP SET UP
Press [K/L] to point to	LANGUAGE [ENGLISH]
	CAPTION [OFF]
“CHANNEL SET UP”, then press
[ENTER].

2 Begin channel scanning	– CHANNEL SET UP –

Press [K/L] to point to “AUTO CH

ADD / DELETE CH (CATV)

PROGRAMMING”, then press B AUTO CH PROGRAMMING [ENTER].

The tuner scans and memorizes all the active channels in your area.

3After scanning

The tuner stops on the lowest memorized channel.

NOTES:

•When “AUTO CH PROGRAM- MING” is activated where there

is no TV signal input, “NO TV	NO TV SIGNALS
SIGNALS” will appear on the
SIGNALS” will appear on the
display after the completion of
channel scanning.

•The unit may recognize CATV channels to be TV channels if reception condition is poor. In this case, check the antenna connection and try “AUTO CH PROGRAMMING” again when reception condi- tions are better.

•Channel memory programming is NOT neces- sary when connected to a cable box or satellite box. Just select the channel for cable box or satellite input (ex. CH3) on the unit, then select your desired channel on the cable box or satel- lite box.

ADDING/DELETING CHANNELS

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

1 Select “CHANNEL SET UP”	- TV SETUP -
Press [SETUP].	B CHANNEL SET UP
Press [K/L] to point to “CHAN-	V-CHIP SET UP
	LANGUAGE [ENGLISH]
	CAPTION [OFF]
NEL SET UP”, then press
[ENTER].

2 Select “ADD/DELETE CH”	– CHANNEL SET UP –
Press [K/L] to point to	B ADD / DELETE CH (CATV)
“ADD/DELETE CH”, then press	AUTO CH PROGRAMMING
[ENTER].

3Enter the desired channel number

Press [CH. K/L] or the Number buttons until your desired channel

	number appears. (You can also	08
	press [K/L] to enter it.)
	• You must precede single-digit	ADD / DELETE
	• You must precede single-digit
	channel numbers with a zero	(Example: CH8)
	(Example: 02 ... 09).	(Example: CH8)
	(Example: 02 ... 09).

•When selecting cable channels which are higher than 99, press [+100] first, then press the last two digits. (Example: to select channel 125, first press [+100] then press [2] and [5].)

4Delete (or add) it from (or into) memory

Press [ENTER]. The channel number changes to light red. The channel is deleted from memory.

•To delete another channel, repeat steps 3 to 4.

•If you press [ENTER] again, the channel is memo- rized again.

Added channel : Light blue

Deleted channel : Light red

5Exit the channel setup mode

Press [SETUP] to exit the menu.

NOTE:

•To confirm that channel(s) has been deleted or added, press [CH. K/L].

- 15 -