GPX TD3222 manual Connecting a TV Antenna, Connecting Basic Cable, Connecting a Set-Top box

Setup

Connecting a TV Antenna

Requires a TV antenna (not included).

1.Connect a VHF, UHF, or HDTV antenna to the RF Input on the television.

2.Press the Source button to switch to TV mode.

3.Press the Setup button to access the setup menu.

4.Press the Arrow () buttons to highlight the CHANNEL icon. Press the Enter button.

5.Press the Arrow () buttons to highlight SIGNAL TYPE. Press the Arrow () buttons to select AIR.

6.Press the Arrow () buttons to highlight AUTO CHANNEL SEARCH. Press the Enter button to begin scanning for available channels.

Connecting Basic Cable

Requires a cable connection.

1.Connect a cable to the RF Input on the television.

2.Press the Source button to switch to TV mode.

3.Press the Setup button to access the setup menu.

4.Press the Arrow () buttons to highlight the CHANNEL icon. Press the Enter button.

5.Press the Arrow () buttons to highlight SIGNAL TYPE. Press the Arrow () buttons to select CABLE.

6.Press the Arrow () buttons to highlight AUTO CHANNEL SEARCH. Press the Enter button to begin scanning for available channels.

Connecting a Set-Top box

Requires a Set-Top Box (not included).

If your Set-Top Box has an HDMI Output:

•Connect the HDMI output on the Set-Top Box to the HDMI Input on the television using an HDMI cable (not included).

If your Set-Top Box has a Composite Video Output:

•Connect the video output on the Set-Top Box to the Composite Video Input on the television using an A/V RCA cable (not included). Connect the audio output on the Set-Top Box to the RCA Audio Input on the television.

If your Set-Top Box has a Component Video Output:

•Connect the component video output on the Set-Top Box to the Component Video Input on the television using a component RCA cable (not included). Connect the audio output on the Set-Top Box to the RCA Audio Input on the television.

After connecting your Set-Top Box:

•Press the Source button to switch to YPBPR, AV, or HDMI 1, HDMI 2, or HDMI 3, to match the connection used.

Auto Scanning for Channels

The Auto Channel Scan must be run before any channels can be viewed on the television.

1.Press the Source button to switch to TV mode.

2.Press the Setup button to access the setup menu.

3.Press the Arrow () buttons to highlight the CHANNEL icon. Press the Enter button.

4.Press the Arrow () buttons to highlight SIGNAL TYPE. Press the Arrow () buttons to select AIR.

5.Press the Arrow () buttons to highlight AUTO CHANNEL SEARCH. Press the Enter button to begin scanning for available channels.

8