Grundig GPVR1250 instruction manual Installing the Batteries, Using the Remote Control

Page 6

Installing the Batteries

Remove the battery cover from the remote control and put place 2 x AAA size

batteries inside the compartment. Make sure to match the + and - of the batteries with the

marks inside the battery compartment

1.Open the cover

2.Install batteries

3.Close the cover

N OPE

OPEN

Using the Remote Control

To use the remote control, point it towards the front of the digital set top box. The remote control has a range of up to 7 metres from the set top box at an angle of up to 60 degrees.

The remote control will not operate if its path is blocked.

Sunlight or very bright light will decrease the sensitivity of the

remote control.

5

Image 6

Contents Digital TV Recorder Table of Contents Introduction What is DVB-T?Accessories In the Box About This ManualSafety Information Remote Control Remote Key FunctionInstalling the Batteries Using the Remote ControlFront Panel and Rear Panel Illustration Rear panelConnecting to Television Aerial and RF cable TV AerialConnecting to a Television Connecting to a Surround Sound System Switching On for the First Time Channel settingGetting Started LCN On/Off System Setting Time SettingTime Zone Setting TimeZone SettingLanguage Setting Parental SettingConversion Change Pin CodeTV Shape StandardFormat Hard Disk PVR SettingTime Shift Enabled/Disabled HDD InformationClear Channels Factory SettingRestore Default System InfoChannel List Adding a Favourite Channel Deleting a Favourite ChannelViewing a Favourite Channel Booking List EPG Menu Electronic Programme Guide Record Operations Help and Advice Problem Probable cause What to doPower Supply DecoderConnections Guarantee