Jensen JN102 manual

JN102

*ANTENNA FOR WIRELESS FM MOD

**See Antenna Note Below

*OPTIONAL RELAY BOX

SIRSWB

UNIT (BACK VIEW)

			CHOKE
				Power Harness
				Item #3
To Secondary AV Monitor
12 VDC Power and Ground	INPUT	RCA-Female
	VIDEO			TO
			LINE	OPTIONAL	Line Out-L (White)
Auxillary			OUT	ADDITIONAL
		Patch Cord		MONITOR
video display			VIDEO
		RCA Male to Male			Line Out-R (Red)
			(Yellow)		Line Out-V (Yellow)

TV

ANTENNA

PODTVT

To TV Antenna In

Dome Light

Power Source

Power Connector

4 Pin

Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR

Accessory	Power Harness
	Item #3
Harness - Optional

(P/N:8010730)

Red RCA (Audio Right)

White RCA (Audio Left)

Yellow RCA (Video)

"Y" Adapter for use with Non-Stereo Installations Item# 5

OPTIONAL

Figure A

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

3)Pull the wire tie loop tight and cut off the excess.

4)Connect the 12 pin harness to the mating connector on the Video Monitor.

5)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground.

6)Verify all functions of the System before final mounting of the finished assembly.

7)Mount and connect the Television antenna. (Optional)

Note: A VCP or other A/V Component can be connected to the video monitor system using a second

source component harness (purchased separately, part number: 8010730). This harness would plug into the Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= AV1, VCP or VCP with TV Tuner (Mini-Din on main PCB) 2= AUX-IN (VCP, Game or future DVD etc...)

3= Built-in DVD

4= TV (TV Tuner)

*NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the wireless FM Modulator be unplugged. See Figure A for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed FCC limits for wireless transmission. When installing the unit position the antenna for best reception.

-6-