Grundig GDP 1600P manual Trouble Shooting, Symptom Check and Action No Power

TROUBLE SHOOTING

Should your DVD player develop a problem, please check below before

requesting service:

Symptom	Check and Action
No Power	Check if the power cord has been properly connected to the power outlet.
	Check if the main power button on the DVD player has been switched on.
Remote Control	Make sure that the Main Power button on the DVD player has been switched on.
Does not play	No disc, load a disc.
	Disc has been loaded upside down. Place the disc with the label side up.
	Disc's region code does not match to the player.
	Disc's rating level is higher than the player's rating level setting
	Disc is not correct type for the player.
	Disc is damaged or dirty, clean the disc or try another disc.
	Moisture may be condensed inside the player. Remove the disc and
	leave the unit power on for one or two hours.
No Picture	Check if the TV set has power on, use TV remote to select A/V signal for
	DVD rather than broadcast.
	Check if the system connection is proper and secure.
	Check if the connection cables are damaged.
	Clean the disc.
	Please press OPEN button,then press PROGRAM and ZOOM button to
	return factory default status.
Picture	The disc is dirty or damaged. Clean the disc or try another disc.
noise / distorted	Reset the color system of the TV set.
	Try by connect player direct to the TV set, without via a VCR for example.
Picture not full	Select the screen format from the player's SETUP MENU,
screen	see "SETUP MENU" of this manual.
	Select the screen format from DVD disc menu.
Problem	Following message will display when there is a problem with the loaded disc:
message display	"WRONG REGIONAL DISC " : Disc's region code dose not match to the player.
on screen
	"WRONG PASSWORD" : The player refuse to play a disc with rating
	level higher than the player's rating level setting.
	"WRONG DISC " : The player is equipped with automatic disc
	quality detection software. When the player detects a problem disc or a
	damaged disc, the player may keep playing the disc at lower quality or
	stop playing, depending on the damage level of the disc.
Malfunction	Press and hold the standby button (if any) for about 5 second to power off.
	Should the player develop a malfunction, unplug the player for
	30 minutes. After 30 minutes, power on the player and the restore
	function should reset the player.

18