Special
Settings for motorised antennas (DiSEqC 1.2)
Your television set supports motorised satellite systems in compliance with DiSEqC 1.2. This function allows the satellite antenna to be oper- ated via the television set.
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select the line »DiSEqC 1.2« with »V« or »Λ«. Select the option »On« with »<« or »>«
– The line »User Mode« is active.
Note:
7Additional operations are explained in the following sections.
User mode
You can adjust the alignment of the satellite an- tenna to each individual satellite. These settings will be saved so that the antenna can later be easily guided to each saved alignment.
1Select the line »User mode« with »V« or »Λ« and press »OK« to confirm.
– The »USER MODE« menu appears.
2 Select the preferred option with »V« or »Λ«.
–»Satellite«: »Press OK«, select a satellite with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
–»Transponder«: »Press OK«, select the transponder from which the signal is being
received with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
–»Moving Mode«: Use »<« or »>« to select the option »Discrete« or »Continuous«.
–»Discrete«: Moves the antenna in defined steps to the west and the east.
–»Continuous«: Moves the antenna to the west or east continuously.
–»Step Size«: Use »<« or »>« to select the number of steps with which the antenna should turn. »Step Size« is only active when the »Transport Mode« was set to »Discrete«.
–»Move Motor«: Aligns the antenna with the selected satellite. Use »<« to align it to »West«, use »>« to align it to »East«.
–»Go To Stored Position«: Aligns the antenna to a saved satellite position. Up to 50 posi- tions can be saved. »Press OK« and then select the saved position with »<« or »>«. Press »« (green) to confirm – the anten- na will be aligned with the saved position.
–»Store Stored Position«: The current anten- na alignment is saved.
3Press »MENU« to end the setting.