Convenience
Setting the date and time
Your television set detects the difference in time to Greenwich Mean Time (GMT) automatically, as long as the channel selected transmits a time signal. You can also set the difference in time manually – for example, when the correct time is not detected automatically or does not corre- spond to local time for other reasons.
1Select the line »Time Adjustment« with »V«, then select the option »Manual« with »<« or »>«.
–The lines »Time Zone« and »Daylight Sav- ing« are active.
2Select the line »Time Zone« with »V« and press »OK« to confirm.
– The »Select Time Zone« menu appears.
3Select the appropriate time zone with » »<«, »>«, »V« or »Λ and press »OK« to confirm.
4Select the line »Daylight Saving« with »V« and use »<« or »>« to set the option »Auto«, »Off« or »On«.
5Press »MENU« to finish the setting.
Note:
7If the option »Auto« is selected in the line »Time Adjustment«, the television set auto- matically adapts the time to the time signal from the respective broadcaster. However, different channels may also use time bases which are different to those of your country; e.g. foreign broadcasters. In these cases, reminders and planned recordings may be annulled due to the time difference.
Timer settings
Entering the switch-off time (sleep timer)
In the »Sleep Timer« menu you can enter a time for the television to switch off. After this time has elapsed, the television switches to standby mode.
1Select the line »Sleep Timer« with »V« or »Λ«.
2Enter the
Note:
7To switch off the function, use »<« or »>« to set the
3Press »MENU« to end the
Switch-on timer
In the »Auto On« menu you can enter a
–at the preselected volume and the preselected television channel.
1Select the line »Auto On« with »V« or »Λ« and press »OK« to confirm.
2Select the line »Mode« with »V« or »Λ« and use »<« or »>« to select when the television should switch on.
3Select the line »Input Source« with »V« or »Λ« and use »<« or »>« to select the input source.
4Select the line »Service Type« with »V« or »Λ«
and use »<« or »>« to select the preferred op- tion (ATV, DTV, Radio or DATA).
5Select the line »Channel« with »V« or »Λ« and use »<« or »>« to select the preferred channel.
Note:
7The line »Channel« is only active when the in- put signal currently in use has been set. If no entry has been made, then the first channel of the selected input source will be used.