PC Setup, DVD Setup | Haier L2009-A, L1709-A, L1910B-A, L2011W-A

VGA IN

Connection Instructions

PC Setup

You can use your LCD-TV as a monitor for your personal computer using a VGA cable (not supplied).

Connection and use steps: 1.Read the user guide supplied with your computer and ensure that it has

a VGA connector; 2.Make sure that the power of the LCD

-TV and the PC are off; 3.Connect a D type 15-pin VGA interface

cable ( not supplied ) to the VGA video interface connector on the PC. Then connect the other end to the VGA video interface connector on the back of the LCD-TV.Tighten the screws on the VGA connectors once they are firmly connected;

4.Turn on the power of the LCD-TV first , and then turn on the power of the PC; 5.Press the TV/AV button to set the video input mode of the LCD-TV to PC-RGB;

6.Check the image on your TV. There may be noise associated with the resolution, vertical pattern, contrast or brightness in PC mode. If noise is present, change the PC mode to another resolution, change the refresh rate to another rate or adjust the brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card can not be changed,change the PC graphic card or consult the manufacturer of the PC graphic card.

PC input

Mode	Resolution		Line frequency KHz	Frame frequency KHz
VGA	640	480	31.5KHz	60Hz
SVGA	800	600	37.9KHz	60Hz
XGA	1024	768	48.4KHz	60Hz

Note: All above listed are subject to VESA Criteria.

DVD Setup

How to connect

Connect the DVD video outputs (Y, PB, PR) to the COMPONENT(Y, Pb, Pr) IN jacks on the TV and connect the DVD audio outputs to the AUDIO IN jacks on the TV, as shown in the figure.

NOTE: If your DVD player does not have component video output,use S-Video.

How to use

1. Turn on the DVD player, insert a DVD.

2. Use the TV/AV button on the remote control to select