Mr. Coffee PR17, PR14 Paramétrage De L’Horloge E T De L A Minuterie, PRX20, PRX23, PRX28 & PRX29

PARAMÉTRAGE DE L’HORLOGE E T DE L A MINUTERIE

(PRX20, PRX23, PRX28 & PRX29)

INDICATEUR PM	PARAMÉTRAGE	Paramétrage	BREW SET	INDICATEUR
	DE L’HEURE	des Minutes		MARCHE/ARRÊT

HOUR MIN BREW

7:00

AFFICHAGE DE L’HORLOGE	AUTO / ARRÊT LUMIÈRE INDIQUE	INDICATEUR
	QUE L’AUTO BESOINS D’ÊTRE REMIS	MARCHE/ARRÊT/AUTO
	À L’ÉTAT INITIAL

To Set the Clock

1.Turn the Control Switch to OFF.

2.Plug the power cord into your electrical outlet. The Clock Display will flash until you set the time.

3.Alternately press and hold the HOUR and MINUTE buttons until you reach the current time. The PM Indicator Light in the display will illuminate to indicate PM time.

To Pre-Set the Brewing Time

Press and hold the BREW button while setting the desired brew time with the HOUR and MINUTE buttons. The PM Indicator Light in the display will illuminate to indicate PM time.

NOTE: It is not necessary to set the clock in order to brew coffee. If the HOUR or MINUTE buttons are not pressed, the clock will display 12:00 and will not change. You must set the correct time in order for the clock to begin operation, or to brew at a pre-set time.

To Brew Automatically at the Pre-Set Time

1.Follow Steps No. 1 through No. 5 in the “Brewing Coffee” section of these instructions.

2.Turn the Control Switch to OFF and then to AUTO.

3.Brewing will begin at the time you have preset and the coffee will remain hot in the decanter for two hours. To keep your coffee hot for an additional two hours, turn the Switch

from AUTO to ON.

IMPORTANT

To Reset AUTO Brew at Pre-Set Time

The programmable timer will NOT automatically brew the next day if left in the AUTO position after its last use. This is a safety feature. If the OFF Indicator Light in the lower right hand corner of the Clock Display is illuminated, reset

AUTO BREW by turning the Control Switch to OFF and then to AUTO.

16