Westinghouse MT80A TILT manual Installation to Single Wood Stud Wall, Skip to on

Page 4

Installation to Single Wood Stud Wall

WARNING

Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components.

1

Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. Based

on its edges, draw a vertical line down the stud’s center. Place tilt assembly (B) on wall as a template, making sure

that the two mounting holes are over the stud centerline. Level tilt assembly, and mark the center of the two holes. Drill two 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the tilt assembly is level, secure it using two #14 x 2-1/2" wood screws (G) as shown.

Skip to step 2 on page 6.

WARNING

Tighten wood screws so that tilt assembly is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.

Never tighten in excess of 80 in. • lb (9 N.M.).

Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.

Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.

B

G

4 of 8

ISSUED: 01-17-06 SHEET #: 202-9091-1

Image 4
Contents Features Accessories Tools Needed for AssemblyTable of Contents Parts List Description QtyInstallation to Single Wood Stud Wall Skip to onInstallation to Solid Concrete or Cinder Block SolidAttaching Adapter Plate to Flat Panel Screen For Vesa 75 Mounting PatternInstalling and Removing Flat Panel Screen Adjusting the Tilt Angle of the Flat Panel ScreenLimited Five-Year Warranty