Westinghouse MT80A TILT manual Installation to Solid Concrete or Cinder Block

Page 5

Installation to Solid Concrete or Cinder Block

WARNING

When installing Westinghouse wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual con- crete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica- tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components.

1

Make sure that tilt assembly (B) is level, use it as a

template to mark two mounting holes. Drill two 1/4"

(6 mm) dia. holes to a minimum depth of 2-1/2"

(64 mm). Insert anchors (C) in holes flush with wall as shown (right). Place tilt assembly over anchors and secure with two #14 x 2-1/2" screws (G). Level, then tighten all fasteners.

WARNING

Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage screws, greatly reducing their holding power.

Never tighten in excess of 80 in. • lb (9 N.M.).

WARNING

Always attach concrete expansion anchors directly to load-bearing concrete.

Never attach concrete expansion anchors to concrete covered with plaster, drywall, or other finishing mate- rial. If mounting to concrete surfaces covered with a finishing surface is unavoidable, the finishing surface must be counterbored as shown below. Be sure concrete anchors do not pull away from concrete when tightening screws. If plaster/drywall is thicker than 5/8", custom fasteners must be supplied by installer.

1

concrete

 

 

surface

 

 

C

Drill holes and insert anchors (C).

2

B

 

G C

Place assembly (B) over anchors (C) and secure with screws (G).

3

Tighten all fasteners.

SOLID

 

 

CONCRETE

CINDER

 

 

BLOCK

C

 

 

 

 

 

INCORRECT

VIEW

wall

concrete

plate

 

 

 

CUTAWAY

 

plaster/

 

dry wall

 

 

CORRECT

wall plate

concrete

 

plaster/

 

drywall

B

G

5 of 8

ISSUED: 01-17-06 SHEET #: 202-9091-1

Image 5
Contents Features Table of Contents Tools Needed for AssemblyAccessories Description Qty Parts ListSkip to on Installation to Single Wood Stud WallSolid Installation to Solid Concrete or Cinder BlockFor Vesa 75 Mounting Pattern Attaching Adapter Plate to Flat Panel ScreenAdjusting the Tilt Angle of the Flat Panel Screen Installing and Removing Flat Panel ScreenLimited Five-Year Warranty