Operating the box
Basic operating instructions
Switching on for the first time
You need to perform automatic channel tuning when you turn the box on for the first time
To perform automatic tuning:
1.Make sure your box is connected to the mains and that it is connected to the aerial
2.Press to turn the box on. After a short time, a welcome menu appears 2. Press the OK button to enter the tuning menu.
3.Press OK to begin the automatic tune
4.The box searches for and displays all the available TV and radio channels
5.Once the automatic search has been completed, you will be prompted to select ‘Yes’ to see the list of channels or ‘No’ to start watching TV.
Note: You can
Standby
Press to put the box into standby, Channel Zero’s services and content are loaded in standby. See Channel Zero on page 29.
The box automatically goes into standby after 3 hours if you do not use the remote control. You can adjust this time by changing the TV settings. See TV on page 25.
Note: You can make the box in passive standby pressing for 3 seconds.
However, this will cause Channel Zero’s content to be lost and the box will have to be
Source selection
Press the TV / R button to switch between TV and radio channels.
14