Sharp 25N-M100 warranty Antenna Connections, Antennas

B. Separate VHF/UHF

A. Combination VHF/UHF

Antenna Connections

Antennas

•The antenna requirements for good color television reception are more important than those for black & white television reception. For this reason, a good quality outdoor antenna is strongly recommended.

The following is a brief explanation of the type of connections that are provided with the various antenna systems:

1. A 75 ohm system is generally a round cable with F-type connector	F-type connector
that can easily be attached to a terminal without tools (not supplied).

The F-type connector should be finger tightened only.

2.A 300 ohm system is a flat “twin-lead” cable that can be attached to a 75 ohm terminal through a 300-75 ohm ADAPTOR (not supplied).

75-ohm coaxial

cable (round)

300-ohm

twin-lead cable

(flat)

OUTDOOR ANTENNA CONNECTION

•Use one of the following two diagrams if you connect an outdoor antenna.

A:Using a VHF/UHF combination outdoor antenna.

B:Using separate VHF and/or UHF outdoor antenna.

•Connect an outdoor antenna cable lead-in to the COAXIAL CABLE CONNECTOR on the rear of the TV set.

VHF/UHF ANTENNA

300/75-ohm

ADAPTOR (not supplied)

	or	300-ohm
VHF/UHF		twin-lead
ANTENNA

75-ohm coaxial cable

REAR OF TV

REAR OF TV

VHF UHF

ANTENNA ANTENNA

300-ohm twin-lead

COMBINER

	300-ohm(not supplied)
	twin-lead
	IN OUT
or	75-ohm coaxial
	cable

CABLE TV (CATV) CONNECTION

•A 75 ohm coaxial cable connector is built into the set for easy hookup. When connecting the 75 ohm coaxial cable to the set, screw the 75 ohm cable to the COAXIAL CABLE CONNECTOR.

•Some cable TV companies offer “premium pay channels”. Since the signals of these premium pay channels are scrambled, a cable TV converter/descrambler is generally provided to the subscriber by the cable TV company. This converter/descrambler is necessary for normal viewing of the scrambled channels. (Set your TV on channel 3 or 4. Typically one of these channels is used. If this is unknown, consult your cable TV company.) For more specific instructions on installing cable TV, consult your cable TV company. One possible method of utilizing the converter/descrambler provided by your cable TV company is explained below.

Please note: RF switch equipped with position A/B (not provided) is required.

“A” position on the RF switch (not supplied) : You can view all unscrambled channels using the TV’s channel keys.

“B” position on the RF switch (not supplied) : You can view the scrambled channels via the converter/ descrambler using the converter’s channel keys.

RF switch (not supplied)

Two-set
signal	Cable TV Line
splitter
(not
supplied)

OUT IN

Cable TV converter/

descrambler (not supplied)

NOTE:

•Consult your SHARP Dealer or Service Center for the type of splitter, RF switch or combiner that might be required.

6