Sharp LC 26SB27UT operation manual Specifications, Model LC-26SB27UT

Appendix

Specifications

	Item			Model: LC-26SB27UT
LCD panel				26” Class (26 Diagonal)
				Active Matrix (a-Si TFT LCD)
Resolution				1,049,088 pixels (1366 x 768)
TV	TV-standard (CCIR)			American TV Standard ATSC/NTSC System
Function	Receiving		VHF/UHF	VHF 2-13ch, UHF 14-69ch
	Channel		CATV	1-135ch (non-scrambled channel only.)
			Digital Terrestrial	2-69ch
			Broadcast (8VSB)
			Digital Cable*1	1-135ch (non-scrambled channel only.)
			(64/256 QAM)
	Audio multiplex			BTSC System
Audio out				5.0W x 2
Terminals	Rear	INPUT 1		AV in, S-VIDEO in
		INPUT 2		AV in
		INPUT 3		COMPONENT in, Audio in (Share with INPUT 2)
		INPUT 4		HDMI in with HDCP, Audio in
		INPUT 5		HDMI in with HDCP
		INPUT 6		15-pin mini D-sub female connector, Audio in (φ 3.5 mm jack)
		DIGITAL AUDIO		Coaxial Digital audio output x 1 (PCM/Dolby Digital)
		OUTPUT
		ANT/CABLE		75 Ω Unbalance, F Type x 1 for Analog (VHF/UHF/CATV)
				and Digital (AIR/CABLE)
OSD language				English/French/Spanish
Power Requirement				AC 120 V, 60 Hz
Power Consumption				67 W (0.7 W Standby with AC 120V)
Weight		TV + stand		20.7 Ibs./9.4 kg
		TV only		17.4 Ibs./7.9 kg
Dimension*2		TV + stand		261/32 x 20 x 99/16 inch
(W x H x D)		TV only		261/32 x 1813/64 x 361/64 inch
Operating temperature				+32°F to +104°F (0°C to +40°C)

*1 Emergency alert messages via Cable are unreceivable.

*2 The dimensional drawings are shown on the inside back cover.

•Typical time for power output decrease of about one-half assuming continuous use in a room with normal lighting, normal brightness and temperature at 77°F/25°C.

•As part of policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

CLEARING THE PASSWORD

If you forget the password, clear the password using the following procedure.

1	Press and hold both VOL – on the TV and press 0 on the remote
	control simultaneously for a few seconds until “Lock” menu appears on
2	the screen.
	Now the old password was cleared. You can set the new password.

The password is

26

		NOTE
.	•	As a precautionary measure, make a note of your
		password above, cut it from this manual, and keep it in a
		safe place.