Sanyo DC-MX30 instruction manual Important Safety Information, You can see this carved picture on

IMPORTANT SAFETY INFORMATION

z	Keep this unit away from dripping or	z	Ensure the unit is plugged into an AC
	splashing water. Ensure that no objects		230 - 240V 50 Hz power outlet. Using
	filled with liquids, such as vases, are		the wrong type of power outlet might
	placed on or near the unit.		damage the unit and even ca
z	To completely disconnect the power		use fire.
	input, the mains plug of apparatus shall	z	Danger of damage if battery is
	be disconnected from the mains.		incorrectly replaced. Replace only with
z	Keep the unit away from strong		the same or equivalent type.
	magnetic devices, heat sources and	z	Before turning on the power for the first
	direct light. Overheating will cause		time, make sure the power cord is
	damage and shorten the life of the		properly installed.
	product.	z	To reduce the risk of electric shock, do
z	Keep the unit away from dust, moisture		not remove cover (or back), no user
	and water.		serviceable parts inside; refer all
z	Don’t obstruct the ventilation vents on		servicing to qualified service personnel.
	the equipment, for example with	z	Never let anyone, especially children,
	newspaper, table-cloths, curtains or soft		push anything into holes, slots or any
	furnishings.		other opening, as this could result in a
	Minimum 10 cm distances around the		fatal electric shock.
	apparatus for sufficient ventilations.	z	Do not use the unit in areas where
z	Do not use strong chemicals, abrasives		extremes in temperature occur (below 5
	or aerosol cleaners to clean the unit..		℃ or exceeding 35℃) or where it may
z	Store your tape or CD in a cool area to		be exposed to direct sunlight.
	avoid the damage from heat.	z	Do not use the unit in areas where
z	No naked flame sources such as lighted		humidity is too high, for example in
	Candles should be placed on the		bathroom or in a wet basement and the
	apparatus.		like. Use the unit in relativity humidity
			45%~85%.
			This symbol indicates that dangerous
			voltage constituting a risk of electric
			shock is present within this unit.
			This symbol indicates that there are
			important operating and maintenance
You can see this carved picture on the			instructions in the information
			accompanying this unit.

bottom of the main unit.

REMARK: In case of malfunction due to electrostatic discharge or fast transient (Burst), just reset

the product (reconnect of power source may be required) to resume normal operation.

2