Sharp LC-70LE734U Preparation, Antennas, Installing Batteries in the Remote Control Unit

Page 11

Preparation

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. For connecting the antenna cable to the TV, use commercially available cables.

Connecting Antenna Cable

Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

 

 

Home Antenna

1 Cable without a CATV

Cable TV lead-In

terminal (75-ohm)

 

converter

 

Coaxial cable

 

 

2 VHF/UHF antenna

75-ohm coaxial cable (round)

Home Antenna terminal (75-ohm)

3 Combination VHF/

UHF antenna

4 Separate VHF/UHF

antenna

 

 

 

 

Coaxial cable

 

75-ohm coaxial cable (round)

 

 

 

 

or

 

 

 

300-ohm twin-lead cable (flat)

300/75-ohm adapter

 

 

 

VHF

UHF

300-ohm

 

 

ANTENNA

ANTENNA

 

 

twin-lead cable

 

 

 

 

 

 

 

 

 

IN

OUT

 

300-ohm twin-lead cable

Combiner

 

 

 

 

or 75-ohm coaxial cable

 

 

To TV antenna terminal

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools.

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter.

F-type connector

75-ohm coaxial cable (round)

300-ohm twin-lead cable (fl at)

NOTICE F-type connector should be finger-tightened only.

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

F-type connector

75-ohm coaxial cable

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1Open the battery cover.

2 Insert two “AAA” size batteries (supplied with 3 Close the battery cover. the product).

• Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

Do not mix batteries of different types. Different types of batteries have different characteristics.

Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

If you will not be using the remote control unit for an extended period of time, remove batteries from it.

9

Image 11
Contents LC-70LE734U Page Model No Serial No LC-70LE734UIndustry Canada Statement FCC Compliance StatementDear Sharp Customer Additional Safety InformationCaring for the cabinet Precautions when transporting the TVCaring for the front panel Child SafetyContents May Supplied AccessoriesAttaching the Stand Remote control sensor Using the Remote Control UnitInsert the batteries into the remote control unit. See Antennas Installing Batteries in the Remote Control UnitConnecting Antenna Cable PreparationTV Rear/Side Part NamesTV Front Part Names Remote Control UnitDisplaying an External Equipment Image Introduction to ConnectionsExperiencing HD Images Types of ConnectionBack panel vertical inputs Connecting to External EquipmentWhen using Hdmi cable Hdmi 1, 2, 3 or When using DVI-HDMI conversion cable HdmiBack panel Connecting to External EquipmentWhen using Component cable Component When using Composite cable Video 1 orWhen using audio cable Back panel vertical inputs Connecting an Audio AmplifierConnecting an AV Amplifier When using optical fiber cableHDMI-certified cable Connecting a PCWhen using analog RGB cable PC Back panel surface inputs Back panel horizontal inputs Back panel vertical inputsWatching TV Turning On/Off the PowerInitial Installation Language Language settingTo watch TV via a set-top box Air/Cable Antenna settingWatching TV Antenna & Cable/STB CH Search Channel searchWatching TV Completed Examples of the settings confirmation screenChanging Channels Changing VolumeSleep Timer Direct Button OperationPress Input Press Power SavingExample When the input source is TV, COMPONENT, Video 1 or Direct Button OperationThis will present the Closed Caption information display Closed Captions and Digital Closed CaptionsPress CC ExamplesFor 43 programs Press View ModeYou can select the screen size For HD programsLcfont embedded On-Screen Display MenuOn-Screen Display Menu Operation Menu Operation ButtonsOn-Screen Display Menu Menu ItemsAdvanced Picture Settings Picture SettingsAV Mode Changing Pic.Quality OPC SettingColor Gamut Range Color Temp Color TemperatureGamma Adjustment Film Mode 32 pull-downBass Enhancer Audio SettingsAuto Volume SurroundAudio Only Power ControlPower Saving No Signal OffView Option System OptionsMenu Design Input Terminal SettingGame Play Time Icon Light Up SettingDemo Mode Caption SetupCH Setup Initial SetupEZ Setup Broadcasting SetupLanguage ResetWall Mount Audio Setup Individual SetupTV Parental Guidelines When setting an individual content-based rating itemChip Chip is an electronic fi ltering device built into yourReactivating the temporarily released V-CHIP Block How to temporarily release the V-CHIP BlockCanadian English Ratings Canadian French RatingsDigital Caption Info Digital Caption Information Software UpdateInformation IdentificationCall 1-800-BE-SHARP Updating the Software via the NetworkAfter the screen shown below is displayed, press Press Enter to start checking the data in the USBMemory device Select Yes, and then press Enter During the data checking, Checking blinksEthernet cable Home network Dlna server Connecting a USB Memory Device/USB Hard DriveConnecting a Home Network Dlna Server Enjoying Photo/Music/Video PlaybackUSB memory device When displaying the data with the AppsSelect the Files to Play Back Enjoying Photo/Music/Video PlaybackPlaying Back Files on a USB Memory Device Photo ModeButtons for slide show BGM select operation USB MenuSelect Slide Show Interval Select Slide Show BGMSet/Reset All Auto Play Music ModeVideo Mode Buttons for playing mode Buttons for music modeTitle Edition/Chapter Using the operation panelMenu for playing mode USB Menu Menu for file selecting operationsDivX VOD registration DivX VOD deregistration DivX SetupPress a/b to select DivX Setup, and then press Enter USB Device CompatibilityYellow Display the Home Network Dlna Menu Screen Playing Back Files on a Home Network Dlna ServerHome Network Dlna Menu Buttons Description C/dHome Network Dlna Server Compatibility Buttons for playing modeOperating the Connected Equipment Presetting Remote Control FunctionPresetting manufacturer codes Other Viewing OptionsOther Viewing Options Manufacturer codes Controlling Hdmi Equipment Using Aquos Link Using Aquos LinkOne Touch Playback Using Aquos LinkAquos Link Setup Displaying the Link Operation Menu Link Operation MenuOne Touch Recording Start/Stop RecordingManually Changing Aquos Audio Speaker System’s Sound Mode Using the Device Operation PanelTimer Recording Playback of Titles Using Aquos LinkStretch Dot by Dot Using a PCDisplaying a PC Image on the Screen Using a PC Adjusting the PC ImageSetting Audio Input PC Compatibility ChartControl of the TV Commands not indicated here are not guaranteed to operate Using a PC Command tableAbout the original home Using the InternetConnecting to the Internet +Using an Ethernet cable+Using the wireless LAN Using the InternetChecking Your Internet Connection Internet SetupInteractive Service Wireless SetupAquos Advantage Live Displaying Updated Information and Support ServiceOriginal Home Entering Text Software Keyboard About links Using the BrowserFeatured Content When z is displayed in aClose This Tab Using the Toolbar Using TabsSelected item Selected item Description Select ThisEditing Bookmarks Saving the URL of the CurrentOpening a Bookmarked View Settings Browser SettingsSecurity Settings Deactivating the Vudu Function Using Applications via the InternetDeactivating Netflix Function Disclaimers Before attaching/detaching the stand AppendixRemoving the Stand Before detaching or attaching the stand, unplug the AC cordAppendix Setting the TV on the WallOptional Accessory Using an optional bracket to mount the TVPages 26 TroubleshootingPages 23 E203 Troubleshooting Error MessageError code Possible Solution Displayed on a screen E202Secret number is TrademarksModel LC-70LE734U SpecificationsSpecification Wireless LANSpecifications Obtaining source code Information on the Software License for This ProductSoftware composition Software developed by Sharp and open source softwareSoftware Copyrights Information on the Software License for This ProductLimited Warranty Calling for ServicePage Unit inch mm Unité pouce mm Unidad pulgada mm Dimensional DrawingsSharp Electronics Corporation