Sharp LC-60LE630U operation manual Precautions when transporting the TV, Caring for the Cabinet

Page 5

IMPORTANT SAFETY INSTRUCTIONS

Outdoor Antenna Grounding — If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

 

 

ANTENNA

 

 

LEAD IN WIRE

 

GROUND

ANTENNA

 

CLAMP

 

DISCHARGE UNIT

 

 

(NEC SECTION 810-20)

ELECTRIC

 

 

SERVICE

 

GROUNDING

EQUIPMENT

 

CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250)

NEC — NATIONAL ELECTRICAL CODE

Water and Moisture — Do not use this product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.

Stand — Do not place the product on an unstable cart, stand, tripod or table. Placing the product on an unstable base can cause the product to fall, resulting in serious personal injuries as well as damage to the product. Use only a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the product. When mounting the product on a wall, be sure to follow the manufacturer's instructions. Use only the mounting hardware recommended by the manufacturer.

Selecting the location — Select a place with no direct sunlight and good ventilation.

Ventilation — The vents and other openings in the cabinet are designed for ventilation. Do not cover or block these vents and openings since insuffi cient ventilation can cause overheating and/or shorten the life of the product. Do not place the product on a bed, sofa, rug or other similar surface, since they can block ventilation openings. This product is not designed for built-in installation; do not place the product in an enclosed place such as a bookcase or rack, unless proper ventilation is provided or the manufacturer's instructions are followed.

The Liquid Crystal panel used in this product is made of glass. Therefore, it can break when the product is dropped or applied with impact. Be careful not to be injured by broken glass pieces in case the panel breaks.

Heat — The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifi ers) that produce heat.

The Liquid Crystal panel is a very high technology product with 2,073,600 pixels, giving you fi ne picture details. Occasionally, a few non-active pixels may appear on the screen as a fi xed point of blue, green or red. Please note that this does not affect the performance of your product.

Lightning — For added protection for this television equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the equipment due to lightning and power-line surges.

Power Lines — An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

To prevent fi re, never place any type of candle or fl ames on the top or near the TV set.

To prevent fi re or shock hazard, do not place the AC cord under the TV set or other heavy items.

• Do not display a still picture for a long time, as this could cause an afterimage to remain.

• To prevent fi re or shock hazard, do not expose this product to dripping or splashing. No objects fi lled with liquids, such as vases, should be placed on the product.

Do not insert foreign objects into the product. Inserting objects in the air vents or other openings may result in fi re or electric shock. Exercise special caution when using the product around children.

Precautions when transporting the TV

When transporting the TV, never carry it by holding or otherwise putting pressure onto the display. Be sure to always carry the TV by two people holding it with two hands — one hand on each side of the TV.

Caring for the Cabinet

Use a soft cloth (cotton, fl annel, etc.) and gently wipe the surface of the cabinet.

Using a chemical cloth (wet/dry sheet type cloth, etc.) may deform the components of the main unit cabinet or cause cracking.

Wiping with a hard cloth or using strong force may scratch the surface of the cabinet.

If the cabinet is very dirty, wipe with a soft cloth (cotton, fl annel, etc.) soaked in neutral detergent diluted with water and thoroughly wrung out, and then wipe with a soft dry cloth.

Avoid using benzene, thinner, and other solvents, as these may deform the cabinet and cause the paint to peel off.

Do not apply insecticides or other volatile liquids.

Also, do not allow the cabinet to remain in contact with rubber or vinyl products for a long period of time. Plasticizers inside the plastic may cause the cabinet to deform and cause the paint to peel off.

5

Image 5
Contents LC-60LE630U Supplied Accessories11P07-MX-NM For connectionsImportant Information Dear Sharp Customer Additional Safety InformationCaring for the Cabinet Precautions when transporting the TVCaring for the Liquid Crystal panel Child SafetyRemoving the Stand Attaching the StandOptional Accessory Setting the TV on the WallUsing an optional bracket to mount the TV Hanging on the wallExperiencing HD images Using the Remote Control UnitInsert the batteries into the remote control unit. See Connecting Antenna Cable Installing Batteries in the Remote Control UnitPreparation AntennasPart Names Power button Menu button Input buttonTV Front TV Rear/Side Component terminalsConnecting a PC Connecting to External EquipmentConnecting an Audio Amplifier Initial Installation Turning On/Off the PowerWatching TV Press c/d to select Air or Cable, and then press EnterSleep Timer Changing VolumeDirect Button Operation Changing ChannelsDigital broadcasting audio mode MTS/SAP stereo modeDirect Button Operation Operating On-Screen Display MenuClosed Captions and Digital Closed Captions Press InputPress Input again or press a/b to select the input source Displays channel information being viewed. Press DisplayFor HD programs For PC input modeZoom For 43 programsUsing the control panel of the main unit Using the remote controlOn-Screen Display Menu On-Screen Display Menu OperationOPC Setting Advanced Picture SettingPicture Menu PictureAudio Menu Power Control MenuSetup Menu Language ResetParental Ctrl Parental Control Setting On-Screen Display Menu TV Parental Guidelines Content rating items are setRepeat the same steps for the other items Mpaa Voluntary movie rating systemCanadian English Ratings How to temporarily release the V-CHIP BlockCanadian French Ratings Reactivating the temporarily released V-CHIP BlockOption Menu Identification Auto Sync. for Analog PC Input Mode OnlySoftware Update Appendix TroubleshootingPC Compatibility Chart Troubleshooting Error MessagePC Compatibility Chart below AppendixModel LC-60LE630U SpecificationsInformation on the Software License for This Product Limited Warranty Calling for Service